Part Number: ADS1278-EP Other Parts Discussed in Thread: ADS1278-HT Hello,
Other than the higher temperature rating of HT version, how does the ADS1278-EP differ from the ADS1278-HT?
Does the ADS1278-EP have the same die as the ADS1278-HT?
Thanks…
Part Number: ADS1278-HT Dear madams and sirs,
is the ADS1278-HT available in 64 pin pachage with a high operating temperature of 210°C with the ordering number ADS1278HPAPG4 ?
Part Number: ADS1278-HT Hello TI Team.. I use a ADS1278SHKP in a application but i'm not sure where to connect the thermal pad of this chip. Has it to be connected to GND and has it to be soldered on the PCB.
Regards
Franz Stemmer
Part Number: ADS1278-HT Tool/software: Does the ADS1278HFQ require some kind of machine to form the leads?
https://www.digikey.com/en/products/detail/texas-instruments/ADS1278SHFQ/2353226
Part Number: ADS1278-HT Hi,
I´m using the ADs1278-HT in low power mode with a Master-Clock of 102.4kHz resulting into a datarate of 200Hz. The modulator (sampling frequency) runs at 12.8 kHZ. I have following questions.
-> First:What status has the…
Part Number: ADS1278-HT Other Parts Discussed in Thread: ADS1278 Hi team,
Debugging the ADS1278-HT has encountered an issue where incorrect data was found while fetching data using the TDM Dynamic position Data mode.
The following figure shows the…
Part Number: ADS1278-HT Hello,
Is the VCOM voltage generated by an actual resistor divider as shown in the datasheet? If so, what are these resistor values? Thanks.
Part Number: ADS1278-HT Other Parts Discussed in Thread: ADS1278-EP , Hi,
I would like to know relation of ADS1278-HT and ADS1278-EP.
Is ADS1278-HT the device sorted from ADS1278-EP ?
Or are ADS1278-HT and ADS1278-EP different schematic or process…
Part Number: ADS1278-HT Hello Guys,
Good day.
Our customer is using the ADS1278-HT for downhole drilling application. In their application they need to perform some highly precise measurements "as soon as possible" after the device startup. On page…
Part Number: ADS1278-HT Other Parts Discussed in Thread: ADS1278 High temperature testing of three parts at 170C fails after 430/640/700 hours. The 1.8V VDD and 3.3V VCCIO power rails are shorting out and drawing excessive current.
As per the data sheet…