Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: ADS42JB46EVM Other Parts Discussed in Thread: ADS42JB49 , ADS42JB46 , ADS42JB49EVM I see in this post: https://e2e.ti.com/support/data-converters-group/data-converters/f/data-converters-forum/687965/ads42jb46evm-adc-not-outputting-cgs-and-ila…
Part Number: ADS42JB46EVM Other Parts Discussed in Thread: ADS42JB49 I am reading in my ILA sequence transmission that the M configuration bit is outputting 1, which, based on Table 9, means that there are 2 converters in operation. How do I set M=1 converter…
Part Number: LMK04828 Other Parts Discussed in Thread: ADS42JB46EVM , Hi everyone,
I have a question about the "VCC parts of LMK04828" in ADS42JB46EVM design schematic.
Why the FB ( Ferrite Bead ) is chosen as 120OHM@100MHz but not other size?
Part Number: ADS42JB46EVM Other Parts Discussed in Thread: ADS42JB46 , Hi,
Where can I find the footprint files of ADS42JB46 or the evaluation PCB files of ADS42JB46EVM?
Best regards!
Ren Xiangxiang
Part Number: ADS42JB46EVM Hello,
I am looking to connect the ADS42JB46EVM to an FPGA demo board running our own FPGA bitstream. I would like to directly control the SPI interface of both the converter and the pll on the EVM, but there is a CPLD in between…
Part Number: ADS42JB46EVM As the title states I'm having trouble getting the ADC to step through the JESD204 initialization sequence. This is with the eval board connected to a Xilinx KCU116 Ultrascale+ demo board via the FMC connector. What I observe…
Part Number: ADS42JB46 Hi TI,
I design one ADS42JB46 Test Board following the official design 'ADS42JB46EVM'.
Now I want to test the performance(ENOB) of ADS42JB46 chip.
I want to test ENOB under several specific frequency as the you do, so I…
Part Number: LMK04828 Other Parts Discussed in Thread: ADS42JB46EVM , LMK04832 , CDCLVP111-SP , LMK03328 , ADS42JB46 Hi everyone,
1) I don't know why there are 3 kinds "impedance matching" in the design schematic of LMK04828 (in ADS42JB46EVM) because I…
Nan,
Apologies for the delay, you posted to us over the weekend and we're just getting to respond this afternoon. For reference it looks like the questions are in three posts:
https://e2e.ti.com/support/clock-timing-group/clock-and-timing/f/clock…
Part Number: LMK04828 Other Parts Discussed in Thread: ADS42JB46EVM , LMK04821 , ADS52J65EVM , LMK04832EVM , LMK04832 Hi
We would like to use LMK04828 in distribution mode (both PLL off) where source clock has phase noise <-154dBc/Hz@1kHz.
Is the device…
