Part Number: ADS807 Hello:
I USE ADS807E A/D converter. when FPGA out a clock to ADS807E,This clock superposition on analog input signal, as below,THANKS
Hopewu
2020.5.29
Part Number: ADS807 Hi team,
In the case of application circuit (Fig.4), some over voltage (higher than Vs) was seen on IN pin of ADS807E during power off.
Have you ever seen such behavior? If yes, is it OK (no concern about its life time)?
Best…
I apply MIL-HDBK-217F to predict the failure rate of ADS807E.
My question is:How many transistors or MOS in these chips?
And I need the thermal resistance from junction to case (theta-jc) for ADS807E.The datasheet provide only junction to ambient…
Other Parts Discussed in Thread: AFE5807 , AFE5807EVM ADS807E is used in our design, to convert analog input to digital output, expected to
work with 50 MHz clock input.
We have referred the design used in DEM-ADS807E
Evaluation kit (http://www…
Other Parts Discussed in Thread: SN65LBC180A Hi, I am working on a thermal simulation, and I need the thermal resistance from junction to case (theta-jc) for UCC2897PW(2897)、INA326EA、OPA734AIDBV、OPA2335AIDGK、ADS807E、SN65LBC180A、REF3112AIDBZT(R31A). The…
Other Parts Discussed in Thread: ADS8422 , ADS807 , ADS5560 Hi,
I'm designing analog circuit.
Input signal is
Vpp : 7V, 0~ 7V.
wave form : step wave. every 50ns , sensor outputs new information.
ADC must sample it every 50ns.
ADS 8422's…
Hi,
I wanted to confirm that my PCB Layout for my ADS807E was correct for a single ended DC input.
Here is what I have done:
- +Vs pins have a 0.1uF and 10uF cap to ground and supplied with 5V
-Vdrv pin have a 0.1uF and 10uF cap to ground and…
Couple of quick things Akash,
1. Where is your DC bias current path for the V+ inputs to the op amps?
2. This differential I/O op amp circuit sometimes has a common mode oscillation - probably not here, but we did see that in the OPA838 decomp device…
