Part Number: ADS825 I need to give external reference to the ADC ADS825 using a voltage reference IC. I am taking Vs as +5V and I need to adjust the REFT and REFB externally. Please provide the reference scheme for the same. Also please specify if the…
Part Number: ADS825 I am using ADS825E in my new design. I need to know the maximum of VIH, VIL and minimum of VIH, VIL. Please share this ASAP as it is not specified in the datasheet.
Part Number: TMS320F28379D Other Parts Discussed in Thread: ADS825 Hi TIers,
I'm planning to interface Asynchronous EMIF of TMS320F28379D with ADS825, the TI's high speed ADC in my application, timing diagram of which is shown below
My plan is using…
Other Parts Discussed in Thread: ADS825 Dear friends,
Acording to the Spec of ADS825, I can tie PD pin to High/Low to enable/disable the chip, in my design,
I tie VS to +5V and VDRV pin to +3.3V, and my question is:
1. is there an internal pull…
Other Parts Discussed in Thread: ADS900 Hi,
We connected an ADS825E according to the recommendations in Figure 2 from the data sheet, and connected IN port to the Vcm biased by two 1.62K resistor (the resistors are not very accurate and we saw a non…
Couple of quick things Akash,
1. Where is your DC bias current path for the V+ inputs to the op amps?
2. This differential I/O op amp circuit sometimes has a common mode oscillation - probably not here, but we did see that in the OPA838 decomp device…
