Part Number: ADS8327 Hello
I am using ADS8327IBPW with Vref LM285 to read the temperture from the TMP26 .
Could you please check my schematic.
Vref=2.5V
VA+ = 3.3V
VBD = 2.5V
IN+ = 0.7V to 1.2V
IN- = GND
Part Number: ADS8327
Hello,
About the chain mode of ADS8327, it used the separate CS to connect GPIOx of controller, I'd like to confirm if CS could connect together?
Best regards
kailyn
Other Parts Discussed in Thread: ADS8327 I applied following configuration to ads8327 but i didn't get EOC signal. its remains at high;
VA=3.3V, Vref(+)=2.5V, vref(-)=0v(gnd), vin(uni-polar)=0 to 2.5v
i tied sdi pin to 3.3v to use adc in default mode…
Other Parts Discussed in Thread: ADS8327 Hi,
datasheet of the ADS8327 says that ist supports CPOL=0,CPHA=1 (should be SPI mode 1) and CPOL=1,CPHA=0 (should be SPI mode 2). In both of this modes, the master should sample the data at the falling clock…
Other Parts Discussed in Thread: MSP430F5437 , ADS8327 Hello all,
first of all I opened another thread in the ADC forum here, but since there is almost no activity in comparison to this beautiful lively place I would like to ask for some help in here…
Other Parts Discussed in Thread: ADS8327 , MSP430F5437A Hello,
I want to use my MSP430F5437A with an external ADC, therefore I chose the ADS8327 16-bit type, and until now I couldnt find out a easy to understand way to get the data out of this ADC into…
Other Parts Discussed in Thread: ADS8327 , TMS320F2808 We are currently experiencing some problems with the ADS8327 16 Bit 500KSPS Serial ADC.
They work perfectly for a period of time, after a while some of them exhibit small shift in their voltage…
Other Parts Discussed in Thread: ADS8327 Hi,
Another question :
Is it possible (I am sure it is...) to connect an ads8327 ADC to one of the C6748's SPI Port ?
I my application I will need the ADC to work in AUTO TRIGGER mode.
As far as Pin…
Part Number: OPA2376-Q1 Other Parts Discussed in Thread: ADS8327 I was looking at the application circuit figure 27 on datasheet. My question is what is the purpose of RC network there? Is it designed to drive high capacitive load?
I am planning to…
Hi Gang,
Some devices to consider:
ADS8327 : VREF as low as 0.3V, 500KSPS sampling rate
ADS8329 : VREF as low as 0.3V, 1MSPS sampling rate
Best regards,
Samiha
