Part Number: AMC1200-Q1 Other Parts Discussed in Thread: AMC1200 I am creating a six-channel sensor on 4-layer PCB with the use of AMC1200. Are there any concerns to put two devices in the same coordinates but on top and bottom layer. Meaning that die of…
Part Number: AMC1200 Hello everyone, a while ago I used the AMC1200SDUBR for a design to measure AC voltage applied to a single-phase motor with a capacitor. This is the circuit I'm using to measure the voltage:
However, I have a major issue, and…
Part Number: AMC1200-Q1 Other Parts Discussed in Thread: AMC1200 , AMC1200EVM , AMC3301 , INA236 Dear support,
I plan to use TI above 2 TI IC for current & voltage sensing in my design.
Can you help me to check with TI whether my preliminary circuit design…
Part Number: AMC1200 Hi,
I have an application requiring the design of an analogue front end for high bandwidth voltage measurement.
- 1MHz bandwidth up to 1kV amplitude.
The voltage measurement needs to be isolated, and ultimately will be fed into an…
Part Number: AMC1200 When looking on the MCU side of sample code for motor control, the voltage filter pole is needed on the sensing side, but the reference circuits are simple voltage dividers.
I'm working with a platform that uses the AMC1200 for voltage…
Part Number: AMC1200 Other Parts Discussed in Thread: AMC3330 , AMC1311 , AMC1300 , AMC1350 , ISO224 , AMC1351 Hi,
I work on voltage measurment circuit using AMC1200. Can I use simlar considartion to reduce the offset and gain error by using additional R3…
Part Number: AMC1200 Other Parts Discussed in Thread: OPA2227 ,
Hi!
As shown in the schematics below, we're using a AMC1200 to isolate a voltage signal, an instrumentation amplifier (AD8421) to convert the output to single-ended and an OPA2227 (U201B…
Part Number: AMC1200
Hi Team:
My customer use AMC1200BDUB and found the 3KV Surge test will record as C level , it must need manual reset.
So customer trying to add 100Ω in R104 place to fix this, if there any effort for the equivalent input circuit…
Part Number: AMC1200-Q1 Other Parts Discussed in Thread: AMC1200 Hello TI Team,
I am planning to AMC1200-Q1 for AC Voltage Sense. Does AMC1200-Q1 support for AC voltage Sense?
If yes then,
Can you explore me the point VINN and GND1 is short?
or please…
Part Number: AMC1200 Hello , I am planning to use AMC1200 in voltage measurement , there are going to be 2 different ranges 1000Vpeak range and 100Vpeak range.
A relay is used to switch voltage divider branches in order to switch between ranges.
The schematic…