Part Number: AMC1302 Tool/software: Hi, I am now evaluating the schematic and layout technique for LCL filter current sensing for a three phase inverter.
The current is 55A.rms / 80A.peak
Please kindly help to review the following sch and layout and…
Part Number: AMC1302-Q1 Other Parts Discussed in Thread: AMC1302 , TIDA-020018 , AMC3302 Tool/software: I want to perform high-side current measurement for a power converter circuit. My voltage level is +400 VDC. I would like to read it in an isolated…
Part Number: AMC1302-Q1 Tool/software: Hello,
We are looking into using this iso amp for power application. I'm doing tolerance analysis on this with the given shunt.
Could you clarify in the datasheet does Ibias for negative and positive input…
Part Number: AMC1302-Q1 Other Parts Discussed in Thread: AMC1302 , TINA-TI Tool/software: We are evaluating new ICs for higher voltage application. I'm looking for spice model the the AMC1302. I have tried directly converting the tina model to spice …
Part Number: AMC1302 Tool/software: Hi everyone,
I am reading page 57 of Ti's Engineer's Guide to Isolated Signal Chain Solutions and I don't understand why the waveforms of VinAMC and VoutAMC have a 180 degree phase difference.
I would like to…
Part Number: AMC1302 Tool/software: Hello experts
Hope this finds you well.
In the connection method of the input shunt resistor, the Inn and GND1 are shorted. It is said that the accuracy is improved by minimizing the offset, we wonder the reason…
Part Number: AMC1302 Other Parts Discussed in Thread: AMC3302 Tool/software: I was using AMC1302 for bus current measurement of 0-25A. The INN terminal and the GND1 terminal are always shown to be connected in the datasheet. In my circuit the IGBT 'Driver…
Part Number: AMC1302 Other Parts Discussed in Thread: ISO1212 , , AMC130M02 , AMC1300 , AMC3301 , AMC1350 , AMC3330 , TIDA-010960 Tool/software: Hi Team,
My customer would like to design a 240VAC input power detector. Max power is 1.8KW.
Could you…
Part Number: AMC1302-Q1 Tool/software: Hi, Do the OUTP and OUTN outputs have suitable protection for a sustained short to GND2, such that they will function normally afterwards once the short is removed? E.g., a cable flip causing OUTP and OUTN to be…
Part Number: AMC1302 Tool/software: If I use the 10 Ohm input resistors I have a lot of noise at the output. Without the 10 Ohm resistors I have much better performance. Can you give me an explanation for this? Since the circuit was suggested in the data…
