Part Number: AMC23C12 Hi,
I have to connect the AMC23C12 to a uC with input range from 0 V to 3.3 V. If I give 5V at Vdd2, then will the output be ranging from 0 to 3.3 V or is it ranging from 0 to 5V? If it is 5V, I dont know how I can use it fro my…
Part Number: AMC23C12 Other Parts Discussed in Thread: TINA-TI Tool/software: Hi team,
I have down loaded the Pspice model for AMC23C12, and implemented in over current protection circuit in LT spice
While running the simulation its shows some pop…
Part Number: AMC23C12 Hi Experts,
I am currently designing a circuit using the AMC23C12 and would appreciate some clarification on its threshold voltage calculations, reference voltage setup, and input protection.
With a nominal input voltage of 0…
Part Number: AMC23C12 Tool/software:
Good morning, I'm currently trying to use AMC23C12 as overcurrent detector in a SIC-based inverter.
The problem is that I get a spurious response well before reaching overcurrent threshold due to DV/Dt during phase…
Part Number: AMC23C12 Tool/software: I would like to simulate the component AMC23C12QDWVRQ1, however, I did not find the pspice model, is there any pspice model for this component?
regards.
Part Number: AMC23C12-Q1 Hi Expert,
My customer is confusing the pin identify , because they did not know which one is latch pin ?
On datasheet page3 have both output , but other page have latch pin in there.
Do we have any latest revision datasheet…
Part Number: AMC23C12-Q1 Tool/software: Hello,
Is it possible to get the weight/mass (mg) information for following 2 components:
AMC23C12QDWVRQ1
AMC23C14DWVR
Thanks & regards,
Pawel
Part Number: AMC23C12-Q1 Hi team,
Here is a customer question.
Regarding D/S 7.3.5, when should the LATCH pin set to high during power-up behavior in LATCH mode?
Best Regards,
Shoji
