Part Number: AMC3301 Other Parts Discussed in Thread: AMC1300 , AMC3330 Hi experts,
Can HLDO of AMC3301 drive the high side power supply of another AMC1300?
I see that supply current of AMC1300 is about 6mA.
BR
Jim
Part Number: AMC3301 Hi ,
In my current design , i planned to use the single supply FDA amplifier on low side current sensing(Load current :0 - 2A range) input voltage 24V as DC supply. after FDA output to another board ----conversion from differential…
Part Number: AMC3301-Q1 Other Parts Discussed in Thread: AMC3301 Tool/software: Hello,
In testing several new PCBs using this device, a fraction of the circuits exhibit instability, which is shown in the attached video. The trace is DCDC_OUT (high side…
Part Number: AMC3301 Hi team,
I have a customer with the below question on the AMC3301. Let me know what you think and thanks in advance for your help!
"I do have a requirement for my current amplifier development that you could perhaps help me with…
Part Number: AMC3311-Q1 Other Parts Discussed in Thread: AMC3330 , AMC3311
Tool/software:
Hello Experts,
I have attached a snippet of the circuit here,
The idea is to measure the DC voltage which unfortunately, has a common mode component…
Part Number: AMC3301 Other Parts Discussed in Thread: AMC3330 Goodday,
I am designing a circuit for monitoring DC Bus voltages with the AMC3301 amplifier, and currently running some simulations.
I used the excel tool to calculate the required resistor…
Part Number: AMC3301 Tool/software: AMC3301 is used for AC-current sensing of a EV fast-charging station. I am looking for TI solution with similar spec. as AMC3301 but also with over current protection. Thank you.
Part Number: AMC3301 Hi Team,
My customer wants to use the amc3301 for overcurrent protection.The induced current of the block circuit is sampled.
The simulation circuit is shown in the following figure.
When the input signal is a triangular…
Part Number: AMC3301 Hello,
My customer has run simulations using PSpice for TI, but it didn't work as expected. Would you please tell me what they should do for getting expected results?
They referred to the Figure 8-1 on page 27 in the datasheet…
Part Number: AMC3301
Hi,
I am already planning to use AMC3301 for the phase current shunts, but i wish to extend them also for voltage measurment of the dc link positive and negative with respect to NP midpoint.
Would this be OK way to construct…
