Hi Abdin,
and - to achieve proper common mode rejection and suppression of switching noise - don't forget to add a differential amplifier to the output of AMC3302 like shown here:
or here:
This is mandatory :-)
Alternatively, an ADC with differential…
Part Number: AMC3302 Test on AMC3302EVM，±50mV a mplitude sine wave input, the delay of the input and output is 1.7us.(as figure below)
No delay data found for sin input in datasheet.
Need AMC3302 delay time of sin and step signal input. (any test…
Part Number: AMC3302-Q1 Other Parts Discussed in Thread: ADS131B02-Q1 , ADS131B04-Q1 , ADS131B26-Q1 We are trying to design an isolated current measurement design based on a shunt measurement principle for high battery charge and discharge currents. The…
Part Number: AMC3302
Hi Team,
Our customer is utilizing AMC3302 and run into some issues as follows:
Fig 1 is the measured output of the pins via an oscilloscope.
Fig 2 is zoomed in time base where you can see there is 300kHz noise of approx 500mV…
Part Number: AMC3302 Hi.
We switch a series LC-load in a 600V H-bridge.
Today we measure the current using a transducer (LEM HO- series)
I wanted to try to use a shunt instead. So connected a shunt in series with the load.
Connected a AMC3302EVM…
Part Number: AMC3302-Q1 Other Parts Discussed in Thread: AMC3302 There’re several questions shown as below:
The maximum current of battery pack is above 1100A while the current shunt resistor used is 50uΩ. Howerver, the maximum input of AMC3302-Q1…
Part Number: AMC3302 Other Parts Discussed in Thread: AMC3330 Hello, I have a problem with the design of a current and voltage sensor based on the AMC3300 and AMC3302 ICs. It is about DC sensing in a battery operated high voltage system.The AMC3302 circuit…
Part Number: AMC3302 Hello Guys,
Good day.
Our customer have a few inquiries on AMC3302 temp accuracy and we are hoping you could help clarify them:
1. Is the total input offset voltage characterized by Vos of +/-15uV at 25C and +/- 50uV at full…
Part Number: AMC3330 In the isolated amplifiers with integrated DC/DC converter there is some noise at the output pins OUTP and OUTN. I understand that it is assumed that this noise is filtered out by a differential amplifier. But I am not so sure about…
