Part Number: BOOSTXL-ULPSENSE Other Parts Discussed in Thread: LP-CC2652R7
Tool/software:
Hi Team,
I have a question regarding the "Analog light sensor for ULPSENSE" SCS example.
Now I am trying to run this example but it gives a warning at…
Part Number: BOOSTXL-ULPSENSE Other Parts Discussed in Thread: LAUNCHXL-CC26X2R1 , LPSTK-CC1352R We have the BOOSTXL-UPSENSE connected to LAUNCHXL-CC26X2R1 running the multi_sensor app.
We can make a BLE connection from Android running SmartLink Starter…
Part Number: LP-CC2652RB Other Parts Discussed in Thread: BOOSTXL-ULPSENSE , CC2652RB , CC2652R , SENSOR-CONTROLLER-STUDIO , SIMPLELINK-CC13X2-26X2-SDK ,
Hello,
does the CC2652RB support the sensor controller booster pack (BOOSTXL-ULPSENSE)?
The…
Part Number: BOOSTXL-ULPSENSE Other Parts Discussed in Thread: SMARTRFTRXEBK , Hi TI experts,
We are in search of Wi-SUN supported development boards.
On the TI website, BOOSTXL-ULPSENSE, BOOSTXL-AOA, and SMARTRFTRXEBK are listed as "Featured Wi-SUN…
Thank you Arthur and Nathan, Nathan, What would you suggest for the next step then? can you supply a different firmware to be flashed on the BOOSTXL-ULPSENSE? Is it preferable to replace the BOOSTXL-ULPSENSE with the BOOSTXL-SENSORS? Regards, Eran
The BOOSTXL-EDUMKII and the BOOSTXL-ULPSENSE have accelerometers on them:
https://www.ti.com/tool/BOOSTXL-EDUMKII
https://www.ti.com/tool/BOOSTXL-ULPSENSE
Adopting a Booster Pack gives you physical and (probably) electrical compatibility with a…
Hi Pukhraj,
You can use the CC1352R launchpad sensortag if it has the sensors you are looking for: https://www.ti.com/tool/LPSTK-CC1352R
We also have a couple of sensor booster packs you can use with any LaunchPad:
- https://www.ti.com/tool/BOOSTXL…
Hi
The current consumption referred to in https://www.ti.com/lit/swra578 is measured on a CC13x2 LP connected to a BOOSTXL-ULPSENSE board.
It run the default “Capacitive Touch for ULPSENSE” example on the sensor controller, and the “cap_touch_ulpsense…
Part Number: CC2642R-Q1 Other Parts Discussed in Thread: BOOSTXL-ULPSENSE Team,
My customer who tries to use Capacitive Touch with SCE has some question about Procedures the Sensor Controller Studio has. (Currently using LaunchPad + BOOSTXL-ULPSENSE…
Hi Ray Vincent,
All of the pins described as "analog" in the datasheet can be used. You will also need to use one of these pins for the reference resistor.
The capacitive touch buttons are part of the BOOSTXL-ULPSENSE, so I will link to the design…
