Part Number: CDCE62005 Other Parts Discussed in Thread: LMK6C Hi,
I need your expert advice.
The idea is to use this component as basic LVDS output OSC with 3 outputs 250, 50 and 100MHz
1. I can not use pins 43 (Auxin), SECREF(3,2), and PRIREF(45…
Part Number: CDCE62005 Hello team,
I have a quick question about CDCE62005.
Is there performance difference between when using PRI_REF and when using SEC_REF?
Best regards,
Part Number: CDCE62005 Hi,
We meet a problem: we use two CDCE62005 multistage cascaded, some the 2nd chip's lock signal on the board is unlock. Our SCH is the same as TI 6678 EVM, using SPI interface from FPGA, and the config file is created from TI…
Part Number: DAC3482EVM Other Parts Discussed in Thread: DAC3484 , DAC34H84 , DAC3482 , DAC34SH84 , CDCE62005 Hello team,
I am using DAC3482EVM with TSW1400EVM.
On the p.9 of the DAC348xEVM user's guide, it says,
Y3: FPGA Clock 1. This clock…
Part Number: CDCE62005 Hello team,
VIN(VIN-V/IN) of Differential input mode is specified with 0.1V(min) and 1.3V(max).
Does this 0.1V mean 0.1Vpp which is from +/-0.025V swing around common voltage at pos side and -/+0.025V swing around common voltage…
Part Number: CDCE62005 Hello team,
Could you let me know if there is any requirement on below pins during power up? for example, it needs to be pulled to GND, floating is fine, and so on.
AUX_IN
PRI_REF+/-
SEC_REF+/-
SPI_CLK
SPI_LE
SPI_MOSI…
Part Number: CDCE62005 hello
1. is there any specific order that the CDCE62005 registers need to be programmed?
2. in the datasheet "Table 39. Register and Default Setting" the initial (default) contents of REG0008 is not specified
what is the…
Part Number: CDCE62005
Hi,
I am attempting to use the TI CDCE62005 to generate 50M, 100M and 150 MHz from a 25MHz crystal.
I am using the GUI to calculate the dividers. The device wont lock in the GUI (not sure the little light actually indicates…
Part Number: CDCE62005 Hi team,
Do you have any loop filter calculation tool for CDCE62005?
I found CDCE62005EVM GUI has loop filter calculation tool , but can I use this tool without EVM?
or do you have any excel calculation tool on Loop filter…
Part Number: CDCE62005 Hi,
This is Hemila from HCL Technologies working in Dhiviya' s team.
We are trying to write to EEPROM using CDCE62005 but we are not able to do it. We can write and read all SPI registers.
Is there any possibility to write…
