The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: CDCE6214 Tool/software: Hi,
We are using CDCE6214 for our current project. Can you please verify the below circuit and provide your feedback.
Thanks,
Vishal K
Part Number: CDCE6214-Q1 Tool/software: Thank you for your reply.
We've tried configuring the PLL parameters via PLLplatinum V1.6.9, but we get a significant resonance at the desired fvco frequency (a screenshot and the source file are attached).…
Part Number: CDCE6214 Other Parts Discussed in Thread: CDCI6214 , Tool/software: Hi team,
We thought to use CDCE6214RGET part in our design for PCIE gen 3 or Gen 4 application,CDCE6214 will support LP-HCSL output clock technique.
In CDCE6214RGET data sheet…
Part Number: CDCE6214-Q1 Other Parts Discussed in Thread: ADC3683 , Tool/software: Hello,
We plan to use CDCE6214-Q1 with ADC3683.
We use TICSs Pro to configure the register of CDCE6214-Q1 as following :
1. Ref freq diff of 60MHz / PFD freq = 60MHz / Integer…
Part Number: CDCE6214 Tool/software: So I'm reading:
"By factory default, the page 0 EEPROM has pin mode enabled, meaning that the 4 GPIO pins are configured as individual OE pins.
R0[0] defines the pin mode, but this bit will only take effect…
Part Number: CDCE6214 Tool/software: Hello,
TI indicated in https://e2e.ti.com/support/clock-timing-group/clock-and-timing/f/clock-timing-forum/1332369/cdce6214-linux-driver-support/5072589#5072589 that a Linux driver was expected to be available in…
Yufeng,
Multiple CDCE6214 devices can exist on the same I2C bus, the device does not pull the bus low when there is not I2C access. The one thing to be careful of is that there must not be I2C access to other devices on the bus while the EEPROM of the device…
Part Number: CDCE6214 Tool/software: Hello,
Our customer needs to check phase noise data if CDCE6214 is appropriate in his application.
Would it be possible to share the phase noise data in 1.8V, 24MHz input 1.8V, 72MHz output use case.
Best regards…
Part Number: CDCE6214 Tool/software: Hello,
We're currently in the process of designing a FPGA based PCB for which we intend to use a clock generator (such as the CDCE6214) to generate the neccesary clock frequencies. My question is aimed at the input…
Part Number: CDCE6214 Other Parts Discussed in Thread: LMK3H0102 Tool/software: Hi,
I need a 156.25Mhz reference clock for 10Gbps XFI.
1.The soc datasheet says Output Driver Type should be HCSL. I think CDCE6214 is OK though it's output type is LP…