Part Number: CDCE813-Q1 Other Parts Discussed in Thread: LMK04100 Tool/software: Hi expert,
My customer's TDM master has a high jitter that slave cannot stand.
The BCLK is 12.288MHz, the FSYNC is 48kHz. They both need to clean jitter, can one CDCE813…
Part Number: CDCE813-Q1 Other Parts Discussed in Thread: CDCE913 Hi expert,
Our customer will use CDCE813-Q1 as the multiplier signal of the audio clock.
Do the SOC/DSP clock signal be multiplied to the power amplifier, so that the clock can be synchronized…
Part Number: CDCE813-Q1 Other Parts Discussed in Thread: LMK3H0102 Hello team,
My customer is looking for clock solution with the below condition. Do you have more appropriate solution than CDCE813-Q1?
- Only 1 output needed with 3.3V LVCMOS
- Output…
Part Number: CDCE813-Q1 Other Parts Discussed in Thread: CDCE913-Q1 Hi team,
Does TI have CDCE813-Q1 EVM?
I cannot find it on TI.COM.
Can it be replaced by 913?
Thanks
Xiaoxiang
Part Number: CDCE813-Q1 Other Parts Discussed in Thread: CDCE913-Q1 , Hi team,
1. Could you give us all differences between CDCE813-Q1 and CDCE913-Q1?
Which device is better for customer? And which device is cheaper? They will use it for audio MCLK.
2. Could…
Part Number: CDCE813-Q1 Other Parts Discussed in Thread: LMK5B12204 , CDCE913 Datasheet P8 is described recommended specification for timing requirements, but jitter specification is not described.
Is there required input spec for jitter?
Best regards…
Part Number: CDCE913-Q1 Other Parts Discussed in Thread: CLOCKPRO , , CDCE913 , CDCE813-Q1 Hi team,
Our customer is using the GUI of TI ClockPro Programming Software.
We have installed the software, and plug the EVM of CDCE913-Q1
When we click the ok, then…
Part Number: CDCE813-Q1 Other Parts Discussed in Thread: CDCE913 , , CDCE913-Q1 Hi Team,
I’m looking at the CDCE813 and CDCE913 do you have a document with the topline comparison table between these two parts/familes?
They appear to be the exact same…
Part Number: CDCE813-Q1 Other Parts Discussed in Thread: CDCE913 , CLOCKPRO Hi team,
One of our customers uses the CDCE813 as a PCLK jitter cleaner with an input frequency of 24MHz.
I know it needs to operate in PLL mode if clock jitter cleaner is used.…
Part Number: CDCE813-Q1 Other Parts Discussed in Thread: CDCE6214-Q1 Hi team,
My customer are looking for one clock jitter cleaner to use in below application.
The 947 jitter requirement is 0.2UI, which 1UI is equal to 1/(7*fClk)
The PCLK of oLDI is…
