Part Number: CDCE913 Other Parts Discussed in Thread: CDCEL913 Tool/software: Hi,
According to the datasheet:
5.1 Absolute Maximum Ratings (3) SDA and SCL can go up to 3.6 V, as stated in the Recommended Operating Conditions table.
We would like…
Part Number: CDCE913 Tool/software: Dear TI Support Team, I have the following technical questions regarding the CDCE913 device:
1. Does the CDCE913 have ESD protection clamp diodes on its I2C pins?
2. If the answer to question 1 is "Yes", I understand…
Part Number: CDCE913-Q1 Hello team,
CDCE913-Q1 has VDD and VDDOUT pin as a power supply input.
Is there any power up / down sequence requirement?
I don't thinks so but let me double check.
Regards,
Hirata
Part Number: CDCE913 Although some time has passed, I would like to report that the issue discussed in the thread below has been resolved. The root cause was on the main MCU side. We apologize for any inconvenience caused.
By adjusting the pull-up resistor…
Part Number: CDCE913 Hi team,
Until now, there haven't been any particular issues, but suddenly devices that fail to lock the PLL have started appearing. Since this phenomenon persists with the device, I believe the device itself is the cause. I'd like…
Part Number: CDCE913 Hi team,
The recent datasheet update included changes to the power-up sequence. Why was this modified? I need to understand the impact on existing systems, so please explain the background for this change.
Best Regards, Ryu.
Part Number: CDCE813-Q1 Other Parts Discussed in Thread: CDCE913 Hello!
I was reading a similar topic: https://e2e.ti.com/support/clock-timing-group/clock-and-timing/f/clock-timing-forum/1190722/cdce813-q1-vs-cdce913
But I still have some doubts.…
Part Number: CDCE913 Tool/software: Hi TI team，
When a 24MHz clock is input through Pin1 of CDCE913, there is no clock output from Pin11 in the default mode. According to the description in 7.3.2 of the CDCE913 specification, the default should be Bypass…
Part Number: CDCE913 Tool/software: Hi,
Please advise me on question bellow
The CDCE913 datasheet states as bellow.
8.3 Power Supply Recommendations
When using an external reference clock, XIN/CLK must be driven before VDD ramps to avoid risk…
Part Number: CDCE913 Tool/software: Hello all,
we would like to program CDCE913's EEPROM.
The datasheet states in "7.3.4 Data Protocol": Before beginning EEPROM programming, pull CLKIN LOW. CLKIN must be held LOW for the duration of EEPROM programming…
