Hi Gerhard,
CDCEL913 in PLL bypass mode may be an option. Although the crystal reference spec is 8 MHz, I believe 7.68 MHz should work fine.
Regards
Arvind Sridhar
Hi Richard,
You're correct - it seems like this table is representative of the CDCEL913 in this regard. I will check with design to see if operating this device in this manner would cause damage to the ESD structure on the device.
Gabe
Hi Gabe
I I am using CDCEL913 ,and using clock pro 1.2 for generating register values .
But the bit viewer just displays Reg0-Reg14 register values for "Generic Registers",lost Reg15. The same of "PLL1 Registers" lost Reg31
see my attached image…
Hi David,
Take a look at CDCE913-Q1 or CDCEL913-Q1. These devices are automotive grade and have a wide temperature range of operation (-40C to 125C). The minimum VCO frequency is 80 MHz. There is a 10-bit output divider so the min output frequency is…
Other Parts Discussed in Thread: CDCEL913 , CLOCKPRO Hello,
I am having difficulty in installing the drivers for the CDCEL913 EVM in a Windows7 64-bit environment.
I looked on the forums and saw the following thread:
http://e2e.ti.com/support…
Other Parts Discussed in Thread: CDCE913PERF-EVM , CDCE913 , CDCEL913 Hello,
I bought a CDCE913PERF-EVM Evaluation module.
It was delivered with a CDROM corresponding to an old EVM Evaluation board (with National LabView runtime), not that I bought…
Other Parts Discussed in Thread: CDCEL913 Dear all,
I am using CDCEL913 for generating the 12.288MHz clock.Its PLL is bypassed in default configuration.It generates distorted sin wave in default mode.I need square wave of the same frequency.That is…
Other Parts Discussed in Thread: CDCE913 , CDCEL913 Hello Everyone,
We are trying to program the CDCE913. All of the drivers are correctly installed, the jumpers are correctly set, and the voltage LEDs are lit.
When the software is started, I press…
