Part Number: CDCEL925 Other Parts Discussed in Thread: USB2ANY , , LMK03318 Tool/software: Hi,
I would like to be able to program CDCEL925 using the the I2C protocol with the USB2ANY. I am using the USB2ANY since my end application uses the LMK03318…
Part Number: CDCEL925 Other Parts Discussed in Thread: LMK03318 , CDCE925 , CDCEL937 , CDCEL949 , LMK5B12204 Hi,
I have created a clock tree using this PLL. I am using a fast NAND gate to create waveforms of 25% duty cycle. The schematics are shown…
Part Number: CDCEL925 Other Parts Discussed in Thread: LMK1C1102 , SN74AXC1T45 , CDCE925 Tool/software: Hi,
I am using this PLL in my design. I have a question on the series output impedance that I should use. The outputs are driving a bunch SN74AUC…
Part Number: CDCEL925 Other Parts Discussed in Thread: CLOCKPRO Hello,
I'm supporting LG display customer in TI Korea. He has concerns about how to manage/control Fvco.
do we have a calculation sheet so for easy supporting for customer? Thanks in…
Part Number: CDCEL925 Hi Team,
Please help to confirm CDCEL925 can achieve this application. Thanks
Input 27MHz, output 27MHz and 24MHz simultaneously.
Thanks
Part Number: CDCEL925 hi,
it's my first time to evaluate the CDCEL925, some questions need your help to clearify, thank you.
1> what's the external XTAL's ppm limitiation? any range of ppm is suitable for CDCEL925?
2> If my external XTAL is 27MHz…
Part Number: CDCEL925 Hi Team,
We measure the delay time of Xtal and signal output (Y1), and fine about 700ms delay.
We think it takes too long. Is this delay time normal? Or can be adjusted?
Please refer to below waveform and schematic, and give…
Part Number: CDCEL925 Other Parts Discussed in Thread: CLOCKPRO We meet one issue for CDCEL925 that, some of our chips do not work on our board, the log shows as followed
PIPE:LRT: External PLL on I2C reg 09, 00 was written but 01 was read PIPE:LRT…
Other Parts Discussed in Thread: CDCEL925 Dear all,
I'm programming the CDCEL925 via I2C directly on system, but I'm experiencing the following issues:
I1 - programming the internal registers seems to have no effects;
I2 - readings on every address…
