Part Number: CDCLVD1216 Tool/software: Need the physical packaging information for CDCLVD1216RGZT. Datasheet says RGZ0048, however there are a few different versions (A, B, C, D, etc.) with slightly varying dimensions and tolerances. I need to know what…
Part Number: CDCLVD1216 I have the question for the package for the following two parts:
first one. PN "CDCLVD1216RGZ";
2nd one PN "CDCLVP1216RGZ";
these two have the same package called "RGZ", but the data sheet showed different center pad, first…
Part Number: CDCLVD1216 Hello team. Our system provides an AC coupled LVDS clock into another module CDCLVD1216 clock input. We have recently discovered that the module expects a DC coupled input (the VREF on the third party CDCLVD1216 is not connected;…
Part Number: CDCLVD1216 Dear Expert Good day! Our customer need to confirm that ,CDCLVD1216RGZ/CDCLVP1216RGZ these two have the same package called "RGZ", but the data sheet showed different center pad, first one's enter pad is smaller than 2nd one. why…
Part Number: CDCLVD1216 Hello team,
I have relative question about CDCLVD1216 propagation delay vs temp performance. I found its performance as below. http://e2e.ti.com/support/clock-and-timing/f/48/p/809200/2994713#2994713?jktype=e2e
Mean…
Part Number: CDCLVD1216 Hello,
I am using CDCLVD1216 to drive my TTL signal to fanout to 16 LVDS receivers.
But i am seeing a lot of reflections on LVDS output.
May i know the possible root cause. Can CDCLVD1216 drive 13" PCB microstrip line and…
I was able to locate some data for CDCLVD1216. I hope this helps.
Mean Values
temperature
-40C
-40C
-40C
25C
25C
25C
85C
85C
85C
t_PD (ps)
1685.29
1614.88
1526.66
1786.60
1710.58
1621.39
1938.23
…
Part Number: CDCLVD1216 Dear Sir,
We need to distribute 2 signals (2-5KHz and reset(DC) ) into 90 signals each.We identified part CDCLVD1216 to use in two levels.Please confirm whether the part is suitable for this application.Also suggest if any other…
Part Number: CDCLVD1216 I will be using DC connection to the Inputs, therefore I will not be needing the VAC_REF0/1. What would be the recommendation for VAC_REF0/1 pins for best operation? Should I just leave them open?
Kind regards,
Part Number: CDCLVD1216 I am using this IC to distribute signal (2-5KHz) tousing this IC and drive to 2 m length.Whether this IC is sufficient for drive or i need to use LVDS driver additionally.
