Part Number: CS-AMPLIFIER-ERROR-TOOL Tool/software: Hi,
Hope you’re doing well. This is Sanjana Renganatha Desigan from Quantum Circuits, Inc. We are currently designing an RF front end and need advice for connectorized amplifiers that meet the requirements…
Part Number: CS-AMPLIFIER-ERROR-TOOL Other Parts Discussed in Thread: LMP7721 , IVC102 , OPA928 Tool/software: Dear TI team, is there a solution to amplify the output of Faraday Cup from nA level to mA level (threshold of our oscilloscope) without time…
Part Number: CS-AMPLIFIER-ERROR-TOOL Other Parts Discussed in Thread: DAC39RF10 , OPA365 , TLV365 , OPA863 , OPA607 Hi Team,
Can you suggest suitable op amp for our requirement.
We have selected DAC39RF10 devices for the generation of pulses.
…
Part Number: INA4181-Q1 Other Parts Discussed in Thread: TLV9002-Q1 Tool/software: Hi team,
My customer wants to know what's the benefit of current sensing amplifier (INA4181-Q1) over general purpose amplifier (TLV9002-Q1). Besides the saving of external…
Part Number: INA228-Q1 Other Parts Discussed in Thread: INA236 , INA228 , INA238
Tool/software:
Hello Team,
I was calculating current measurement error using your Current_Sense_Amplifier_Comparison_and_Error_Tool and got the below results.
…
Part Number: LMP8481 Tool/software: Hello-
I am using the -S and -T versions of the LMP8481 current sense amplifier.
I am using TI's "Current Sense Amplifier Comparison and Error Calculator" https://www.ti.com/tool/CS-AMPLIFIER-ERROR-TOOL spreadsheet…
Part Number: UCC28950 Hi All,
I am using UCC28950 IC in my design. I have few doubts regarding CS pin as below.
1. Is this pin is to limit the input or output current of the converter?
2. If yes, what is the set value/reference value used for…
Part Number: UCC15240-Q1 Other Parts Discussed in Thread: UCC25800 , Tool/software: Hi Team,
Customer uses it to supply amplifier, so there is no Qg and fsw, but seems calculation tool will produce a mistake under this condition, which is shown as below…
Part Number: TPS7H5005-SEP Tool/software: Hello,
I am designing an isolated power supply using this controller. I currently have my controller placed on the primary side of the isolation barrier and was wondering if I was to use an external isolated…
