Part Number: CSD18542KCS Other Parts Discussed in Thread: TINA-TI , Tool/software: TINA-TI or Spice Models Hi,
I am designing a programmable dc electronic load circuit. I am using the CSD18542KCS for the current sink part.
The circuit is quite the…
Part Number: DRV8701 Other Parts Discussed in Thread: CSD18542KCS , , CSD18532Q5B Hello,
We have design Motor driving board using DRV8701. We are facing below issue.
Motor Specifications. PMDC, 24VDC, 500W
When we are using CSD18542KCS MOSFET and…
Part Number: DRV8701 Other Parts Discussed in Thread: CSD18542KCS Hello,
We have develop board around DRV8701 for Motor driving.
Motor Specification:
Voltage: 24VDC from battery
Watt: 500W.
We are using CSD18542KCS MOSFET with 5mohm sensing…
Part Number: CSD18542KTT Other Parts Discussed in Thread: CSD18542KCS , LM25116 , CSD18543Q3A , CSD18534Q5A Hello team,
Regarding following thread,
CSD18542KTT: RθJC
I discussed about thermal resistance with the customer.
The customer is considering…
Part Number: LM5088 Other Parts Discussed in Thread: CSD19502Q5B , CSD18532KCS , CSD18542KCS Hi ,
I am in the design stage of DC-DC 18VDC/7A Board with the use of LM5088 IC. As per the Reference circuit provided by TI, the suggested Mosfet M1 part No…
Hi Jejomar, Thanks for reaching out. Please find my answers below:
These parts are optional place holders, which are not mandatory to operate this design. R45, R46 R55 and R56 allow to tie the gate to ground in case there is no defined output signal…
Hello James,
I check the EVM schematic. We have used MOSFET CSD18542KCS whereas EVM has used CSD88537ND. Comparing the gate charge of both, CSD18542KCS has Qg=44nC whereas CSD88537ND has Qg=14nC. I observed the waveform of gate voltages and output when…
Salil,
In the MOSFET forum, I can only speak to your second question. The CSD18542KCS should behave according to Figure 2 in the datasheet. That is to say, at Vgs =10V, Vds =.1V, you should be seeing about 30A, which matches the 3.3mOhm resistance of…
Hey Samir,
Thanks to reply.
Yes, this is the exact circuit (Constant current load) I am building for my VRs to be tested for fast rising transients. And the mosfet is also used in my circuit.
Below is the circuit that I had simulated using TINA…
Manikanta P
This is Kurata from Hinox.
thank you for your reply.
Attached is the requested UCC256402 circuit diagram (for submission).
Thank you for your consideration.
New power supply(TI提出用).2023.0412.pdf
