Part Number: DRV8323 Other Parts Discussed in Thread: CSD19506KCS Hello,
I'm using DRV8323 SPI version to command CSD19506KCS MOSFETS , with the following configuration:
IDRIVEP_HS : 120 mA
IDRIVEN_HS : 240 mA
IDRIVEP_LS : 120 mA
IDRIVEN_LS…
Shai,
I apologize. It was not clear in the original post that this device was meant to operate in the saturation region. Is this for hot swap?
What VDS do you need to withstand the 10ms, 26A pulse for? Our best SOA 80V device would be the CSD19506KCS…
Part Number: LM5175-Q1 Hello, my team has been working on integrating the LM5175-Q1 buck-boost into our design. We have an input voltage ranging from 6.5 - 32V, and a 24V output at 12.5 A peak current. We have been attempting to simulate this circuit…
Other Parts Discussed in Thread: DRV8301 , CSD19506KCS I have been trying to determine if the DRV8301 will drive 6 CSD19506KCS N-Channel Mosfets to run a three phase motor. Any advice on the matter would be very helpful. Max current would be 100A.
Shai,
As the guide states, there are two parameters you will need to adjust in the FET selection to support your use case; voltage rating and package.
An 80-100V FET will be suitable, but you will also need to change the layout to support a TO-220 package…
increasing the PWM rate is dependent on the driver, FETs, and the MCU (mostly related to interrupt time processor loading).
I wouldn't use DRV8301 for this high of PWM frequency application. We are about to release a new TI Design for high current…
Part Number: UCC27524A Other Parts Discussed in Thread: UCC27524 Hi
My customer has the following application in UCC27524A, then used IFX MOSFET BSC016N06NS, would you please help to check the drive capability confirmation, thanks.
Regards
…
Hi Niklas,
Thank you for your reply.
So C22 and C31 are not used? Could you please confirm that?
Reading another similar document: TIDA-01352: on page 11, two kinds of red cross were used, a small one and a big one (please see attached document…
