Part Number: DEM-OPA-WSON8-EVM Good afternoon, is it possible for you to provide the gerber files of the mentioned evaluation board?
Thanks in advance,
Pablo.
Part Number: DEM-OPA-WSON8-EVM Other Parts Discussed in Thread: OPA858DSGEVM , OPA858 Can you provide the size/type of passives and SMA connector for the EVM?
Regards, Bernd
Hello Beomyu,
Thank you for providing an update on the setup for your testing and lab work. I am going to look into any recommendations I may have for you; please look at the two FDA EVMs I shared above if you would like to consider an alternative EVM…
Morning Folin,
If you read the discussion for the converter EVM using the THS4541 it says they see the same glitch as you do - I think this is because they did the filter wrong, normally you want the diff C right at the ADC inputs as the last element…
Hello Masao,
I was able to find the original gerber files for the EVM; however, since it is an older EVM, it was designed using Protel PCB Design software. If you have any questions please reach out.
THS SINGLE DGN REVC.ZIP
Best Regards,
Ignacio
Hello Ekta,
As this EVM is a blank EVM board and you would need to populate the components yourself, TI does not have any pick & place or assembly files for the components on the DEM-OPA-SOT-1A EVM.
You may use the component descriptions in Section…
Part Number: ADC3683 Other Parts Discussed in Thread: THS4551 , , , THS4541 Hi,
I used THS4551 to drive ADC3683 and found large glitch (200mV peak) on the nodes V_P and V_N.
The waveform is scope calculation result V_P - V_N. The scope bandwidth is 200MHz…
Part Number: ADC3643EVM Other Parts Discussed in Thread: THS4541 , , THS4551 , THS4521 Hi TI
I have looked at the Schematics for the ADC3643EVM to understand how the THS4541 is used with ADC364x in a single-ended to differential configuration. I could not…