Part Number: DP83822I
Hi team, We have serval units that lost network after hours stability test. we use RMII mode
The findings so far: 1. when issue occurred , the TX has packet increment but the RX keeps no change after ping operation
root@**…
Part Number: AM6422 Other Parts Discussed in Thread: DP83822I Hello!
I’m working on a custom board based on AM6422 (part n. AM6422BSDGHAALV) that supports primary boot via MMCSD1 or RGMII Ethernet, selectable through two hardware jumpers as shown in…
Part Number: DP83822I Tool/software: Greetings,
We have a new HW design which interfaces the DP83822 10/100 Phy to an IMX93 over RGMII, and are having issues getting a link to one of our older products.
Our older ethernet device has an optical interface…
Part Number: DP83822I
Tool/software:
Hello TI,
snls505g Figure 9-3 shows the 49R9 termination resistors pulled up to 3.3 V. Please confirm that these should instead be pulled up to AVD, as should those in Figure 9-2.
Part Number: DP83822I Champs:
My cust has used the 822I.
Their System will have the 1.45ms noise from outside the 822I.
My questions:
Q1. They didnt know where the noise coming from, but they confirmed there is 1.45ms noise, so, any input pin…
Part Number: DP83822I Tool/software: Hi Team,
Used for communication card products with multiple communication methods such as EtherCAT, PN-RT, PN_IRT, etc.
Currently, the EMC anti-interference test results of our PN_ST and PN_SRT are relatively…
Part Number: DP83822I We are experimenting with very long (non-802.3 compliant) packets over 100BASE-T physical layer, and see the descrambler on the destination PHY loses lock after ~18,600 octets of payload.
The DP83822 PHY is configured as RMII Master…
Part Number: DP83822I Other Parts Discussed in Thread: TLK105 Dear support team I have a question about the DP83822I regarding the NC pins.
During the chip crisis the DP83822I was not availabe and that's the reason why we have extended our design, so…
Part Number: DP83822I HI TEAMS
Currently planning to use DP83822IRHBR for circuit design. Have questions regarding routing and hope to get your confirmation. Will perform length matching for the RX and TX signal lines separately. Need to confirm what…
