Part Number: AM5708 Other Parts Discussed in Thread: DRA722 Hi,
I try to create system in which IPU and DSP boot before Linux booting on MPU according to the sources below:
processors.wiki.ti.com/.../Early_Boot_and_Late_Attach processors.wiki.ti.com…
Part Number: DS320PR810 Other Parts Discussed in Thread: USB2ANY , Hi Team,
After SigCon installation completed successfully , I followed the instructions provided.
The USB2Any has connected successfully, but the device can not be found (see attached…
Part Number: TDA2EG-17 Hello Champs, SW: VISION_03_08_00_00 HW: own board When running apps.out, a messed message appears in vsdk/link_fw/src/hlos/osa/src/osa_remote_log_clent.c OSA_printf("%s%s\r\n", procName, for the RemoteLog_clientRun thread gRemoteLog_clientObj…
Hi Ram,
I've already run the early-boot-late-Weston usecase successful when in uboot, but when I start the kernel, the display is gone, I doubt the kernel had reset the IPU2 DSP1 DSP2,but I have do "Enabling Late attach" in kernel/omap/arch/arm/boot…
Part Number: TDA2SX Tool/software: Code Composer Studio Hi all,
I've already run the early-boot-late-Weston usecase successful when in uboot, but when I start the kernel, the display is gone, I doubt the kernel had reset the IPU2 DSP1 DSP2,but I have…
Part Number: DS160PR410 Other Parts Discussed in Thread: , , USB2ANY , DS160PR810 Hello
I would like to use Sigcon Architect for design and program EEPROM for custom board, not EVM.
There will be 8x `410`s grouped for one x8 PCIe and two x4 PCIe.…
Hello Keerthy,
Thanks for the reply.
I have same VDD_CPU_AVS_REG power source in my custom board as per below link:
e2e.ti.com/.../DRA829_5F00_TDA4VM_5F00_3Ph_5F00_Dual_5F00_Leo2.0_5F00_PDN_2D00_0C_5F00_v0.18.pdf
- Harshil.
Hi Shravan
My firmware operation GPIO success while load by kernel,
but it failure to operation GPIO while load by uboot.
hardware: VAYU EVM XC5777X REV H ,
usb2 connect usb device with LED power indicator.
test case: Create firmware operate…
Thank you for your response. I have already looked at the EVM datasheet, the UCC28950/1 datasheet, the UCC28950/1 Excel worksheet, and several application notes. I feel that there is plenty of good information on designing the power stage. Right now I…
Hi Irwin,
Sorry I have been on away, please see the attached wavforms. I adjusted the Rsc 20 20K from 2K, I also changed RFB2 so that RFB1 was the same as the EVM, but still no luck with the PFC at 240V. At 50V the PF is good, but as the voltage increases…
