Search tips
Showing 12 results View by: Thread Post Sort by

  • ESD341: Diode Package

    TI Thinks Resolved
    Part Number: ESD341 Tool/software: Hi expert, Is the ESD diode encapsulated (NOT a CSP package)? Thank you! McKenna

  • ESD341: Searching TI solution

    Part Number: ESD341 Hi team There is a good new that we could DIN TI product! Customer is looking for the replacement of AQ3530-01LTG https://www.littelfuse.com/~/media/electronics/datasheets/tvs_diode_arrays/littelfuse_tvs_diode_array_aq3530_01ltg_datasheet…

  • ESD451: 01005 package ESD check

    TI Thinks Resolved
    Part Number: ESD451 Other Parts Discussed in Thread: ESD441 , ESD341 , Tool/software: Hi team, Customer now use RClamp3331Z2C in their system. It's package is 01005(0.4mm*0.2mm), I searched our portfolio, can't get the same package part available…
    • Answered

  • TPD4E004: ESD device selection for USB application

    Resolved
    Part Number: TPD4E004 Other Parts Discussed in Thread: ESD122 , ESD341 , TPD1E05U06 , STRIKE Tool/software: Hi Team, I am working on EVM schematic designing currently. And regarding USB ESD protection, is there any recommendation of ESD device for…
    • Resolved
    • Answered

  • ESD451: Replacement for GBLC03CI

    Resolved
    Part Number: ESD451 Other Parts Discussed in Thread: TPD1E01B04 , ESD341 Dear Team, we are looking for a replacement for following ESD diode GBLC03CI ( used on Analog CVBS output) What part would you suggest to be better replacement ESD451DPL…
    • Resolved
    • Answered

  • [FAQ] DisplayPort Protection

    Resolved
    Back to Interface Home Page DisplayPort Protection Highlights: Data speeds up to 20Gbps 8 data lines, 20 total pins 3.3V, 500mA Input Low capacitance required on data lines Device V RWM Cap (pF) ESD(kV)…
    • Resolved
    • Answered

  • Protection of low voltage interface against ESD, EFT, and surge

    Resolved
    Other Parts Discussed in Thread: ESD341 , ESDS304 , ESDS302 , ESDS314 , ESDS312 , TSD05 , TVS0500 Hi, I have an ethernet port and a serial RS232 interface in my design that I am trying to protect against ESD, EFT, and surge to comply with IEC 61000…
    • Resolved
    • Answered

  • Transient/ESD Protection of RF Input Circuits

    Resolved
    Other Parts Discussed in Thread: TPD1E01B04 , ESD341 There are so many choices for protection devices that I hope to save some time by asking for advice. My application is a receiver input circuit with 50 ohm impedance. The highest operating frequency…
    • Resolved
    • Answered

  • [FAQ] USB Protection

    Resolved
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Resolved
    • Answered

  • [FAQ] Models

    Resolved
    Other Parts Discussed in Thread: PSPICE-FOR-TI Back to FAQ Home Page Interface Protection Guides Part Recommendation Packaging & Layout Models Transient Standards System/Device Level Design Power Dissipation…
    • Resolved

Didn't find what you are looking for? Post a new question.