Part Number: BQ27Z746 Tool/software: Dear Ti.
I have an inquiry regarding the SoC that is calculated when the battery cell is first manufactured as a pack . If the battery cell manufacturer delivers 30% or 68% cells to the pack manufacturer , how…
Hi, Simply by enabling the k3-am625-sk-microtips-mf101hie-panel.dtbo overlay, you can enable OLDI, and DPI is enabled by default (you'll need DPI to HDMI bridge on your custom board). Weston by default has support for extended display over the two; OLDI…
Hello Max,
Thanks for the new information. I have a few more suggestions and questions:
Have you tried the SIR680LDP in your circuit? It's got a lower RDS(ON) than the SiR880BDP.
Is it possible to use two BQ25756's in parallel for your application…
Part Number: LP-CC1352P7 Tool/software: Hello,
I am currently testing Wi-SUN network performance test using TI devices with Linux wpantund and iperf.
My test setup uses a Border Router (Linux + wpantund) and Router Node (Linux + wpantund).
And the…
Hi Thomas,
Thank you very much for your technical support，I change 954's register 0x58=0x5A to 0x58=0x5E,the FSYNC becomed 30HZ. and the camera displayed 30fps.However, the camera is not working stably. It stops generating images after displaying for…
Hi, Ren
I jsut get a new baord and after cut off the baord now I can get the data same with , But I am not sure how to caualute the vaule to reallt tempture.
S:55 F1 ==> R: 55 F1 80 16 50 16 40 16 40 16 S:55 F3 ==> R: 55 F3 00 02 00 02 00 02 00…
Part Number: LM5143A-Q1 Tool/software: Using the 4-phase synchronous buck configuration,
Please find the schematic and quickstart design below.
7127.BUCK CONVERTER.pdf
LM5143A-Q1 Quickstart Design.pdf
we observed the following:
In DEM mode with…
Hi,
OK, finally the compilation is working good.
Now i can't detect the UART BOOT
Trying to use COM12 to boot the image.
I set the DIP SWs on the board as described:
The Power is connected and the UART is connected.
When i connect the…
Part Number: BQ76952 Other Parts Discussed in Thread: EV2400 Tool/software: Good morning,
We had designed a 4S battery using the BQ76952. It works well.
However, last week we noticed the battery had gone dead and wouldn't charge or discharge. I had…
Hi Nick,
Our system uses 50 ohm cables and consider using LMH0324 as a equarizer to compensate cable loss. So I would like to as possible as include an effect of impedance mismatch between 50 ohm of cables and 75 ohm of LMH0324 to simulation. In my…
