Hi,
The first error you are getting is because the latest bqz file that matches your device firmware is missing. Download the device BQ34110 Firmware from the product folder ( http://www.ti.com/product/BQ34110/toolssoftware ) and copy the .bqz file…
Hi Manoj,
In BQStudio, the Learned Full Charge Capacity parameter needs to be updated - it is under the Data Memory -> Fuel Gauging tab.
There are actually many parameters you will need to set up for your specific battery. I developed a spreadsheet…
/cfs-file/__key/communityserver-discussions-components-files/196/3618.bq34110_5F00_dataflash_5F00_notes_5F00_rev03_5F00_20181002.xlsx Hi,
You can use the attached spreadsheet as a starting place. On the first tab, you can select the battery type and…
We have a custom board using the 66AK2E and are having trouble getting DDR3 to run properly at higher speeds. The board will sometimes hang when starting UBoot, usually at the point where it is transferring execution from Flash to DDR3. Other times the…
Hello Jarod,
If you got an error saying "unable to open COM port", it was most likely that you didn't install the driver well or
made wrong connection between laptop and UART of 455.
Please refer to the attached guide for 455EVM setup.
Thanks…
Dear George,
Thanks for your advice. I am submitting one of the source files which demonstrate the problem I mentioned in my previous post.
Exponentiation.pp is in Set A, which has no problem when build with v8.0.4. After I upgrade to v8.3.0…
Hi Colin,
The problem is that the default flash parameter settings for the device are configured for a Li-Ion battery. There are many parameters that need to be updated for lead acid. I am attaching a spreadsheet that should be helpful to find the new…
Hi Elder,
The learning load should be sized to discharge somewhere between C/100 to C/10 for a fixed time duration so that you see a capacity reduction of 1-2%. This video is helpful in describing the End-of-Service feature: https://training.ti.com…
