Part Number: INA111 Other Parts Discussed in Thread: INA331 , INA818 , INA121 , INA332 , , LMP7721 , TINA-TI Hello all,
I am in the process of developing a circuit to measure the device current, the minimum device current in the order of picoamp. The shunt…
Part Number: INA111 Hallo,
i want to juse the INA111 with Gain of 1, 10, 100 and 1000. The Datasheet says that the Offset RTI is 100uV + 500uV/G.
I mean with Gain z.b. 1000 the Offest may be 100 + 500/1000 similar 100.5 uV. In my case I measure with…
Part Number: INA111 Hi, When verifying the INA111 circuit, an output overshoot was observed at the time of pulse input. Please tell me the conditions under which overshoot is likely to occur and the conditions under which overshoot is difficult to converge…
Part Number: INA111 Other Parts Discussed in Thread: OPA192 Hi, We are considering using this device. While checking the graph information, I found a peculiar characteristic. Could you tell me about Gain vs Frequency graph? 1. The amplification factor increases…
Part Number: INA111
Hi,
we are designing a new electronic card on the previous electronic card design we used the INA111AP now we want to use the INA111AU (surface-mount package).
in the datasheet application (see please figure 8 bellow) on the surface…
Part Number: INA111 Other Parts Discussed in Thread: OPA353 Hi E2E forum I have a question
We are students in Gachon University, South Korea.i introduce our experiment. It is a vibration experiment using ultrosound piezo actuator which can increase the…
Part Number: INA111 Hello,
I am working with an INA111 powered with a symmetrical source of +-5V, and the output needs to be single supply (5V). I added an Schottky diode (parallel to the output) to prevent this voltage to be negative. I want to know…
Part Number: INA111 Hello,
I have a INA111BP I am using in a research setting to amplify a signal/reduce noise coming from a non-contact displacement measuring capacitive probe. The probe runs from a coaxial connection to a Capacitec 210-SLC-200Hz pre…
You want low input offset voltage and low input bias current. The INA333 has 25 µV/200 pA, the INA317, 75 µV/200 pA, the INA111, 500 µV/20 pA. (The INA111 does not fit on the EVM.)
What transimpedance do you need? (INA333/317: 2 × 50…
Other Parts Discussed in Thread: INA111 , OPA211 , ADS7883 , OPA227 , OPA37 , INA331 , OPA333 , LMH6647 , OPA365 Hi,
I want to amplify the signal from a load cell for dynamic applications, and I need a overall gain of 1000. The problem is that the signal frequency…
