Part Number: INA126
Hi. I am having problems to use INA126 with load cell. My configuration is: Input common mode Voltage = 2.5V. Power Supply = 5V/0V. Vref = 0V. I would like to know the limits of Output Voltage I will have.
For example, on the picture…
Part Number: INA126 Other Parts Discussed in Thread: INA122 , , ADS1115 , LM7705 , OPA320 I've got a 2 wire pyranometer. It generates voltage 0-40mV based on the strength of the solar irradiation.
I've got in my toolbox INA126 and INA122.
Are they…
Hi Peter,
I just wondered how you are getting on with solving this riddle. While I was waiting, I tried three things out :-
1) Going back to using INA126 on its own
2) Connecting OPA2192 to INA126
3) Trying INA163 on its own
Here's what I found ;-…
Part Number: INA126 What is the input range of INA126 .How small can be the Δ V so that i get a reasonable good output. Is Δ V =.5mv be good enough.
And also what is a good method to reduce noise, because when my hand comes near the circuit…
Other Parts Discussed in Thread: INA126 characteristicsHi,
Could you please help me to identify different of INA126E and INA126EA parts. In the datasheet two parts are same. But there are two parts.
Is there any document, which express of the meaning of…
Other Parts Discussed in Thread: INA126 Hi there,
Currently i'm trying to design a whetstone bridge circuit using load cell. The instrumentation amplifier which im using is the IN126 , and I have a 0-12V single powered power supply breakout.
The input…
Other Parts Discussed in Thread: INA126 , INA216 , INA282 , INA240 , INA199 Hi Team,
The customer wants to used INA126. The datasheet for INA126 is used for the high-side to detect current for the INA126 data sheet.
Can INA126 be used for the low-side? If not…
Other Parts Discussed in Thread: INA126 , TPS65130 , PGA280 , INA826 , TINA-TI I have a 5kg load cell that was chosen because of some existing conditions. Its output goes into a load cell amplifier who's output can be either 0-5 volts or 0-10 volts. The…
Other Parts Discussed in Thread: INA326 , INA126 I am using an INA126PA to monitor the voltage difference between two photodiodes. The one photodiode is used as a light reference. I hooked up two INA126PA instrumentation amplifiers in the way indicated…
Other Parts Discussed in Thread: INA126 Hi !
I am trying to simulate the CMRR of the INA126P instrumentation OP Amp with no success. According to the datasheet, I should obtain a CMRR of 95 db around 10Hz, regardless of the gain. However, when simulating…
