Part Number: INA132 Tool/software: Dear Texas Team,
we received INA132U/2K5 with MSL level 1 instead of 3 and without MBB.
below is the reel's label ;
PO : 103002272
Quantity : 2500 pcs
Date of receiption : 5/11/2024
Delivery note : 629870284…
Part Number: INA132 Other Parts Discussed in Thread: INA827 , INA331 , INA145 , INA122 , INA126 , INA321 , , INA500 , RES11A , INA597 , OPA317 Hi, is it possible (even not recommended) to change the gain?
Regards, Holger
Part Number: INA132
Hi Team,
Good day! We wanted to clarify the input impedance in INA132. We need a clarification on the datasheet value of input impedance of INA132. The datasheet shows common mode and diff mode as 80k ohm whereas we understand…
Part Number: INA132 Other Parts Discussed in Thread: OPA2191 , INA826 , INA126 Hi Team,
The customer would like to use the op amp to design his circuit. The input signal is 0~20mV and it is 100HZ.
After the signal is amplified by the op amp, the output…
Part Number: INA132 Attempting to mount an INA132A and puzzled at the lack of a clear pin 1 index mark.
There's no notch in the package. That circle within a circle is assumed to be locating pin 1 but it's not quite adjacent.
I'm going by that and…
Other Parts Discussed in Thread: INA132 , TINA-TI In the INA132 spec, it says "do not interchange pins 1 and 3 or pins 2 and 5..." How should I interpret this? Can I rely on R1 and R2 to give me a gain very close to -1? Can I tie pins 1 and 3 together…
Other Parts Discussed in Thread: INA132 A customer is asking the following question about the INA132.
Can you get me data on long term gain drift of the INA132? Not pass/fail test data but real measurements? I need to estimate system 1 year accuracy…
Part Number: INA500 Other Parts Discussed in Thread: TLV9042 , OPA170 , INA132 , , TLV9041 , TINA-TI Tool/software: Dear TI, I believe there is a behavioral model simulation quirk where TI op amp output at Vsat_low goes below the lower bias rail even…
Part Number: INA105 Other Parts Discussed in Thread: INA2132 , INA132 Tool/software: I am using a 6-axis load cell which has a built in amplifier. However, the output signal is differential and the analogue inputs I am using are single ended.
Therefore…
