The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: INA133 Tool/software: Hi, Staff
Please confirm the following two points in the INA133U datasheet (SBOS115A).
1. page6 Vo (Output voltage, gain error < 0.1%) The negative value is listed as (V+)-0.8, but since it is on the negative side…
Part Number: INA133 Other Parts Discussed in Thread: INA105 Tool/software: Dear , Instrumentation Amp Support team . We at Disty have issued PCN No. 20250326007.1 to our customer.
RFAB has been added, but our customers are concerned about the CMRR performance…
Part Number: INA133 Tool/software: HI,Staff
INA133 (SBOS115A) page 7 Settling Time test conditions are Vs = ±15V. It is specified as 4μs (TYP) when 0.1%, CL = 100pF, and 5.5μus (TYP) when 0.01%, CL = 1000pF. However, in the graph in Figure…
Part Number: INA133 Tool/software: Hi Staff
The datasheet for the INA133 has been update.
There are differences between the old and new datasheets, so please let me confirm.
INAx133
PCN Number 20250326007.1
There are parameter changes that are not mentioned…
Archie,
If you use Vref=0V on 25V single supply, you would be correct that the INA133 upper input common mode voltage, Vcm, range would be 47V since Vin must be 1.5V from either rail - see below.
However, with Vref of 6V allowable Vcm input range changes…
Part Number: INA133 Dear Team,
We are using INA133U in one of our major project where as can we use INA133UA without any changes. If we use INA133UA instead of INA133U, will affect my circuit anywhere technically. If yes, please advice the major differences…
Part Number: INA133 Hello,
I would like to know the ESD immunity level of the INA 133 and particularly on sense (5) and ref (1) pins.
Are these pins internally protected against ESD ?
Thank you for your support.
Best regards,
Flavien BERTHIER
Other Parts Discussed in Thread: INA133 , OPA192 , TINA-TI , OPA548 I need to construct a V -> I conversion circuit with a gain of 100mA/V and +-200mA drive capability. The frequency requirements are not high, and bandwidth of 2kHz would more than suffice…
Part Number: INA333 Other Parts Discussed in Thread: INA133 , INA630 , INA826 , INA823
Hi Team,
My customer mentioned when powered up the device looks latch-up and then the device would be broken.
Could you check the schematic?
high side sensing: common…
