Part Number: INA152 HEllo
DO nto use TINA much so not very familiar with its quirks...
Pl see attached a simple circuit using INA152.,
I could not get rid of the error.
Would I have found it in u/g? Of TINA?
The model does not follow the rules…
Part Number: INA152 Hello,
I have one query regarding INA152 input offset voltage .Below table offset drift voltage max and typical both values are in +/-.
So the question is at 100 deg cel offset voltage will be +1500uV or -1500uV . what sign do…
Part Number: TLC081 Other Parts Discussed in Thread: INA132 , INA826 , INA188 , INA823 , INA152 , INA154
Hi Team,
I want a circuit to adjust offset a DC output range from -1V to 11V and add offset around 60mV to output.
Do you have any circuit level…
Part Number: INA197 Other Parts Discussed in Thread: INA152 , INA282 , INA213 Hi,
I am trying to build a current sensor for a +/- 2mA sinusoidal current source injected into a 5k to 10k Ohm load. I am using the circuit shown in figure 29 of the datasheet…
Hi Nicolai,
The reason you are seeing this behavior is because you are running into the output limitations of the upper OPA333. I calculate from your input voltage and the formula that your INA152 output should be at 4.95V. For this to happen, the…
Hi all,
I use the OPA2333AMDREP amplifier as the figure 8 of the OPA2333A-EP datasheet with the INA152 (R1=200Ω, R2=22kΩ) and after, the instrumentation amplifier output is amplified by 5.
I have done some thermal tests between -40°C (-40°F) and…
Difference_Amplifiers.pdf
Here is an app note, Published in Analog Zone. Figure 6, page 7, shows a +-200V implementation with +-15V supply rails using a INA148.
Hello Shihab,
Thank you for filling in some of the details.
Since your source is driven by op amps, I will assume they are low-impedance and balanced. Therefore I think you should look at using the INA152.
The INA152 is a single-supply difference…
Hello Iv��n,
An operational amplifier such as the OPA330 can be used to measure the divider voltage even thought the ground reference for the divider, and the operational amplifier, are different. There are different ways to do this, but a straightforward…
Hello Hari,
For the complete story regarding dual-feedback stability analysis see the attached PowerPoint. Slides 100 through 114 are specifically about op amp dual-feedback stability analysis.
This stability slide content was developed by Tim Green…
