Part Number: INA163 Other Parts Discussed in Thread: INA849 KLEIN_INA163preamp (2).TSC
This is a revisit of a previous support issue I had. Back then it was simulation only. Now I have the circuit implemented on a board. It was working but somehow I…
Part Number: INA163 Other Parts Discussed in Thread: TINA-TI Tool/software: An existing design has the input voltage protection diodes attaching to ground rather than V-.
I am seeing non linear distortion (lower half) of 1KHz sinewave as a balanced…
Part Number: INA163 Hi there,
Please could you inform me about terminal finish of the parts INA163UA / INA163UAE4 / INA163UA/2K5 / INA163UA/2K5E4. Could you tell me the thickness of Au in case the terminal finish is NiPdAu or NiAu or Au.
Thanks…
Part Number: INA163 Hello!
I am attempting to use an INA163 for the first stage of an electroencephalography (EEG) tool. For that purpose, this is the design I was able to come up with:
My problem: whenever I plug the power supply, the amplifier…
Part Number: INA163 Other Parts Discussed in Thread: TINA-TI I'm working up a design using the INA163 for a microphone preamp but I also want to include the option of an unbalanced input. What is the preferred method to do this? Thanks.
Hi Jens,
I agree with Alexander. The INA163 has a settling time of 3.5µs which can even increase with the capacitive load of anti-aliasing filter. This is a bit much. So, an additional buffer might be very useful. And don't forget the anti-aliasing…
Part Number: INA163 Other Parts Discussed in Thread: TINA-TI Hai,
I have developed a six channel mixer circuit, I got an small issue in this, I need a high gain and low noise op-amp , i have selected INA163 ic as a pre-amplifier. Can any one provide…
Other Parts Discussed in Thread: INA163 , TINA-TI Hello, I am building an analog signal conditioning board for which the front end is the INA163, I am trying to create a "shelf-filter" type of response with a 22 nF in series with a 680 Ohm resistor, with…
Part Number: INA163 I'm trying to amplify the voltage across a current sense resistor in-line with mains voltage. My INA163 is referenced to a separate ground, isolated from the incoming earth ground. I'm getting no output from the INA163. I have a 200Ohm…
