Part Number: INA169 Tool/software: INA169.pdf
Detection current range: 0A~60A 1. Confirm RS. Is the resistance value appropriate? 2. Is the selected RL resistor value appropriate?
Thanks!
Part Number: INA169 Tool/software: Hi, Can someone please explain the meaning of this absolute maximum rating on this datasheet? Analog Input, Out -0.3 to 40V. Thanks!
Part Number: INA169 Tool/software: Hi Expert,
Good day!
This is about the current regulator circuit. I wanted to use the current sensing IC INA169. I want to be able to sense current from 0-1A. The image below shows the schematic and simulation graph…
Part Number: INA169 Other Parts Discussed in Thread: INA296A , INA296B Hello team TI,
I'm starting a project for a current monitor, with the following characteristics:
- voltage in the range of 30VDC to 70VDC
- maximum current of up to 400A (Imax…
Part Number: INA169 I'm testing out a simple shunt resistor current sensor circuit based on the schematic provided in the datasheet. My Rs is 1mOhm and Rl is 10kOhm.
When passing a current of 0.50A (verified with another current sensor + ammeter), the…
Part Number: INA169-Q1 Other Parts Discussed in Thread: INA169 Hi team,
If VIN+ and V+(supply) drops to 0V while there is a charge on output capacitor connected to OUT terminal.
is there any risk of leakage current path or damage to the device?
…
Part Number: INA169 Hi ,
We have a requirement of measuring 1mA to 4A current with 1mA accuracy.
What will be the INA169 amplifier Gain/output error voltage for these current range?
What are the parameters to be checked to get the accuracy and…
Part Number: INA169 Other Parts Discussed in Thread: INA186 Hi Team,
We were planned to use INA169 amplifier to measure 1mA-4A load current.
Datasheet specify the total output error to typically be 0.5% and in worst case 2% for Vsense=100mV.
In…
Part Number: INA169 Hi currently using the INA169 for current monitoring of our system which as after a relay we are in works of a new version of the board and I want to add a second one before the relay to measure the current flow of a charger to the…
Amit,
This is still a low side configuration the way it is wired. The INA should be placed above the sample to be in high side configuration. This way the shunt sees a DC bias of the supply prior to that voltage being consumed by the load. Also, the…
