Part Number: INA180-Q1 Other Parts Discussed in Thread: INA180 , INA181 Dear TI experts,
I'm using the INA180-Q1 (A version) in an automotive application in differential amplifier configuration for a high side current measurement.
The sense resistor…
Part Number: INA180-Q1 Other Parts Discussed in Thread: INA180 Hi Team,
A customer would like to know the power dissipation of INA180A1QDBVRQ1. It is usually stated in the datasheet but for this device it does not have the value.
Part Number: INA180-Q1 Other Parts Discussed in Thread: INA180 , Hi Team,
My customer is examining the application with GND connection like material attached.
Is it possible to use INA180-Q1 in such application circuit as long as VCM always meet the recommended…
Part Number: INA180-Q1 Other Parts Discussed in Thread: INA180 , INA195A-Q1 Hello community,
We want to measure current with a shunt resistor and INA180. Current might get to inductive loads so when switching off, we expect huge negative voltages (kV).…
Part Number: INA180-Q1 Hi Team,
Our customer is evaluating INA180A3QDBVRQ1 at Figure44 circuit.
When FET is OFF and Bus voltage is 12V, observed around 1.0V at Vs and Output pin.
I guess that there is Diode between Vs and Output pin in device and it…
Part Number: INA180-Q1 Other Parts Discussed in Thread: INA138 , TINA-TI , INA180 Hello,
my customer is using INA180A2QDBVRQ1 (current sense amplifier) in their project.While using this model in SIMetrix 8.3 for simulation work, with PWM signal input the…
Thank you very much for you support.
INA302-q1 seems a bit expensive.
How about INA180-Q1 + TLV3201-Q1 combined solution?
Total cost is lower than INA302-q1 and still seems to meet the requirement from the spec.
Does it meet this requirement…
Other Parts Discussed in Thread: INA181-Q1 , INA180-Q1 , INA193 Hi,
for a new automotive design my customer is looking for a lower cost alternative to INA193AQDBVRQ1. Do you have some good recommendations?
The INA181/INA180 could be an option as long as it meets your error requirements, although calibration would certainly help with this.
If you want to use the INA181-Q1/INA180-Q1 with input resistors, then you will want to calculate the…