Part Number: INA193 Tool/software: Dear team, I am using INA193 in my design to sense 23mA current . for the differential line voltage range is 110V to 150V range. will it work for this higher voltage range.
do we need to add any protection circuits…
Part Number: INA193 Tool/software: I have a circuit using a INA193 to sense the current through a 60m ohm sense resistor. My sense supply is +/-15V. My INA193 supply is 7V. Both + and - circuits are identical except where the +IN and -IN on the negative…
Part Number: INA193 Other Parts Discussed in Thread: INA281 Tool/software: I am looking for a current sensor built with bipolar technology. Until recently, I was using the Zetex ZXCT10XX, but it only supports high-side sensing and positive voltages. The…
Part Number: INA193 Tool/software:
Hi Team,
We are performing the HF test(Induced conducted disturbances test) ranging 150KHz to 230MHz at 10Vrms. In this test we are using a CLAMP and cables (unshielded) are placed inside it and showering…
Part Number: INA193 Tool/software: I am using INA193AIDBVR IC as 20mA current shunt monitor. input range for this IC is 48V to 56V. I need to protect this IC from grater than 56V at pin 3 and 4. can we use Zener diode BZV55-C62 or BAS28 diode for protection…
Part Number: INA193
Support_pin_of_INA193AIDBVT.pdf
Hello, Support team,
I want to know about support pin of INA193AIDBVT.
It is noted that "Support pin may differ or may not be present", but I am not sure whether it exists or not.
Would you…
Other Parts Discussed in Thread: INA193 Hello,
I using INA193 to measure current from isloated power line.
INA193 is connected to 5V in V+ pin, GND to V-.
Vin + and Vin - are connected with 20m oHm resistor, the ground reference of Vin + and Vin…
Part Number: INA193 Hello,
I wanted to ask about some TI PCNs where it states that:
“Upon expiration of this PCN, TI will combine lead free solutions in a single standard part number, for example; INA193AIDBVR– can ship with both Matte Sn and NiPdAu…
