Part Number: INA198 Hi All,
I have a question about INA198. Regarding VOS (Offset Voltage) of Over Temperature, is the TYP value ±5mV? I think ± is necessary. is my understanding correct?
Also, please let me know the minimum VOS value for Over Temperature…
Part Number: INA198 Other Parts Discussed in Thread: INA180 , INA293 , INA290 , INA240 , INA190 , INA186 , INA196
Hello Javier,
In Fig3, there is a problem with the linearity of the INA198 device output.
Q1> The measured current was tested…
Part Number: INA198
Hello.
I created a development board.
Unnecessary 1.52V is supplied to Load in [Fig1] Block Diagram.
The input + 5V is not supplied.
Q1> Please explain why 1.52V is measured.
Q2> Is there a way to disable 1.52V output…
Part Number: INA198 Other Parts Discussed in Thread: INA193 , INA196 , INA197 , INA194 , INA195 , Hi,
Full-Scale Input Voltage is specified 0.15V(typ).
How condition is this?
Best Regards,
Kuramochi
Part Number: INA198 Other Parts Discussed in Thread: INA190 , INA186 Hi all,
I need to measure on the gate of NMOS FET low negative current (-20uA) with negative voltage (-7V).
I think to use INA198 because Vin is from -16V to +80V, but Input Bias…
Part Number: INA198 Hi Sir,
I am Wade from Pixart.
INA198 is used to measure current through our device power (5V).
but I found the abnormal voltage( at VIN+ = 3.3V, VIN- = 3.3V) when disconnect to device side and turn off supply power side ( =…
Hello Team,
I have 2 questions on the safe operation for the devices:
1. If Vin+, Vin- are connected to 60V input, but the supply voltage is 0V, would the operation be safe?
2. If yes, will there be any power consumption on the device?
Thank you…
Other Parts Discussed in Thread: LMP8640 , INA198 Hi, TIer
1. LMP8640 : It is available for Automotive application in the datasheet. So, has it qualified AEC-Q100 certification?
2. INA198 : hope to know how much current would flow through INA198 when…
