Part Number: INA206 Hello Support team,
Is it possible to make INA206 disable state by "RESET"?
Is the function of "RESET" just only clearing the latch of "COMP OUT"?
Best Regards,
Hirokazu Takahashi
Part Number: INA206 Hi sir,
I want to use INA206 in my new design.
I can find 4 resistors in internal block diagram.
8.2 Functional Block Diagram
https://www.ti.com/lit/ds/symlink/ina206.pdf
Can you tell me each resistor value and each resistor…
Part Number: INA206 Hi Guys,
i have a question of "Is the current bi-directional or uni-directional?"
Requires an additional input to determine current flow direction
-Vout > VREF --> the system is sinking current
-Vout > VREF --> the system…
Another iteration of testing. While I was observing the CMP2 OUT (Ch1, yellow), Vref(1.2V) (Ch2, green), and Vout (Ch3, pink), a glitch occurred in Vref(1.2V) and the CMP2 OUT switched from LOW to HIGH and back, while Vout remained constant. Any guess…
Hello Sarmad,
I have not heard from you in a while. As such I presume you have resolved your issue. However, if you are still having issues, feel free to reopen the thread and update us on your progress. If you do re-open the thread, please provide…
Other Parts Discussed in Thread: INA206 Hello, I have a question about INA206.
I attach a circuit.
INA206.pdf
Please teach me the connection of three GND of red circle. Should GND connect to the GND? Should GND connect to the AGND? Should GND connect…
Other Parts Discussed in Thread: INA203 , INA206 Hi,
Could you please tell us the technical difference between INA203 and INA206 although these parts are the current-shunt monitor with dual comparators ?
Best regards, Kato
Thanks Rabab,
I am using the 10-pin device. Here is my circuit:
The circuitry hanging on the RESET pin just keeps RESET = LO for ~100ms after power up.
Here is how I have set V UPR and V LWR :
I want V SNS ~ 200mV (see INA206 data sheet…
Hi Ken,
I have uncovered some potentially conflicting information regarding any internal ESD diode clamps...so rather than speculate I will take an INA206 into the lab and make a few measurements to confirm what you are seeing...I should have this complete…
Hello Mario,
Thank you for your post.
The only way to successfully float the inputs to the device are to also float the supply. Even in this scenario, you need to measure the input voltage with respect to the GND pin of the device to ensure it is…
