Part Number: INA210-Q1 Tool/software: Hi team,
could you help to check what value is the minimum capacitor on V+ pin, from the datasheet, I see the value is 0.1uF. if we can use <0.1uF capacitor(total)?
Part Number: INA210-Q1 Other Parts Discussed in Thread: INA210 Tool/software: Hi team,
customer change the RS from 10 ohm to 1000ohm, we know the resistor would make large error. but we can't understand it - the output is correct when the current flowing…
Part Number: INA210 Hi Team,
I noticed that the HBM ESD rating of INA21xA was changed from 4kV to 2kV(from revision I to revision J), may I know the reason behind this?
Regards,
Charles
Part Number: INA210 Hi Team,
The customer report that when they remove the voltage on V+, but keep 20V on the IN+/-. There is a leakage voltage on the output pin.
I had done the same test condition on the EVM. The behavior can also be duplicated…
Part Number: INA210 Dear Support,
We are using the current-sense amplifiers INA210BIDCKR for output current monitor.
But it has some failed issue when working, analysis found that the pin4(IN+) and pin5(IN-) are shorted with GND.
In order to find…
Part Number: INA210 Other Parts Discussed in Thread: TINA-TI Hi Ti,
We use the INA210 for current measurement ranging from 0.1 mA to 0.9 mA.
The circuit diagram is as shown below.
We have observed a 25 kHz oscillation at the output terminal (PSEQ_MON_VP12P0_MB_AMP1_ST…
Part Number: INA210 Hi Team,
My customer needs to learn if INA210BIDCKR is CUP structure (referring to active circuitry on the die underneath the bond pads) to recognize the material, please kindly help to provide the information.
Thanks.
Part Number: INA210 Hi Team,
My customer is going to use INA210CIDCKR as the second sockets of INA210CQDCKRQ1, do you have any comments? it can be seen form the datasheet that the Operating supply voltage(Vs) of INA210CIDCKR is 5V, but for INA210CQDCKRQ1…
Part Number: INA210 Other Parts Discussed in Thread: INA190 Hi,
Good Day. I have a customer who is working with current sense amplifier. Please see below the two queries of the customer for your reference. Thank you very much.
*******************…
Part Number: INA210 Hello,
We are looking for current sense amplifiers that can be used for 150A bidirectional current measurement low-side? Can you confirm we can use INA21X family for this application? Any other part for 150A bidirectional current…
