Part Number: INA216 Tool/software: Hello,
My customer has a question about the NC pin connection of the INA216.
Please let us know if there is a problem when using the INA216 NC pins below with pin 6 (NC): VCC (3.0V) and pin 8 (NC): GND connected.
…
Part Number: INA216 Other Parts Discussed in Thread: INA210 , INA180 , INA183 Tool/software: Hello,
My customer has a question about the input voltage specification while using INA216A4.
According to the specification table below, the input voltage (Common…
Part Number: INA216 Tool/software: Dear TI experts,
My customer considers applying INA216 instead of chinese part due to quality isuue.
This product is already in mass production so they do not want to change the layout.
the one problem is, package are…
Part Number: INA216 Tool/software: I saw the following graph (Figure 13) in the INA216 data sheet and thought it was wrong.
For INA216 there is Vcm = V+, Output Voltage = Vsense*G, and the figure shows that Vsense = 100mV.
In the red box area of the…
Part Number: INA216 Hi, TI support team
I have a question regarding the INA216 circuit.
[Test content]
1. It is said that the INA216 Chip power uses the power coming into the shunt input, but it does not filter the power
Conducting a test out of curiosity…
Part Number: INA216
Hi TI expert:
I am using Micro_Cap 12.2.0.5 to do the simulation, I used Part Winzid loading INA216A2 PSpice Model (Rev. B) to MC12 lib. But I can't find the proper Shape for INA216 as INA216 is 4 pin device and an ordinary OPAMP…
Part Number: INA216 Hi expert,
My customer is using INA216A1(Gain=25) for monitoring battery charge current.
They have an issue of output error, it is bigger than device spec after power up
Power up : connect plug-in ACDC adaptor at time=0 in the following…
Part Number: INA216 Hi Sir,
Could you please provide the information below:
Based on the INA216 data sheet page12, do you have any recommendation of Zener diode to protect the INA216 with transients above 5.5V?
2. Please advise if it is possible to…
Part Number: INA216 Other Parts Discussed in Thread: INA186 Hi Sir,
My customer using INA216 as High-side current sensing monitor, and would like to ask for your advised for the following:
In application, the load current is 30uA~120mA , and the supply…
Part Number: INA216 I am using INA216EVM and the amplifier with a gain of 200. The current shunt resistor is 0.04 ohms.
I am measuring the output on the scope. However, I am don't know how to calculate (formula) the current consumption from mV. On…
