Part Number: INA220 Tool/software:
1. Will this design work, kindly confirm.
2. Is one high frequency 0.1uf cap is enough for Vs power pin, right?
3. We are trying to measure 0.8V on VBus pin and Gnd, will this work?
Part Number: INA220 Tool/software: Hi Team,
there is a problem with the current reading, which is above 3A.
we want to confirm 0x00 ans how to adjust it? or can it be modify there?
the current setting as follows:
#Rshunt=0.0125
#Current_LSB=0.32
#
Current_LSB…
Part Number: INA220 Tool/software: Hi Team,
we have a few question and want to learn from you,
1. do i have to add this R_filter?
2. is there minmum on resistance value of R_shunt? since resistor have power limitation, our load is 12v/ 4.1A, if there…
Part Number: INA220-Q1 Tool/software: Hi,
Can I get the failure rate (FIT) for this device (INA220BQDGSRQ1)?
I am using the Motor Control mission profile based on IEC 62380 (Table 11 - Mission profiles for automotive). Mean temp ~60 deg C.
Preferred…
Part Number: INA220 Tool/software: I am using the INA220 at the output of a DAC to measure voltage and current. The output range of the DAC is between -7V and +7V. The specifications of the hardware are given as follows: Rshunt = 6200 Ohm Vshunt Max = …
Part Number: INA220 Other Parts Discussed in Thread: INA238 , INA237 , INA226 Hi Team,
My customer report that the current measured by INA220 is always lower than the real current. I see a describe " in continuous mode, so the INA220 will capture new…
Hey JH,
Q1. The source of the 25.1mV offset is the inherent to the INA220 and instrument tolerance.
Q2. It just means that in a population of INA220 there could be some device that have offsets of 25.1 mV. Offsets do no change unless another condition…
Part Number: INA220
I have a requirement wherein I have to measure a 12V that powers stepper motor ICs, the current can range from a few milliamps to 1.5A. Since the stepper motor IC has internal H bridges and I had to do high-side current sensing, so…
Part Number: INA220 We are planning to buy bulk quantity of the below mentioned parts for our projects. So, I need few details about it, please explain in detail.
How much area is required to store 9000 quantities of the part ( INA220BIDGST )? Please tell…
