Part Number: INA220-Q1 Other Parts Discussed in Thread: INA220 Hello,
I am evaluating this part for use in a new board design and need to be able to verify the authenticity/identity of the device via its I²C interface.
Are there any registers that…
Part Number: INA220-Q1 Tool/software: Hi,
Can I get the failure rate (FIT) for this device (INA220BQDGSRQ1)?
I am using the Motor Control mission profile based on IEC 62380 (Table 11 - Mission profiles for automotive). Mean temp ~60 deg C.
Preferred…
Part Number: INA220-Q1 Hi Sirs,
I don't have experience to set I2C address by connect to PIN SCL,SDA before.
Will it make any problem if I connect the A0, A1 to SDA and SCL directly or connect the A0, A1 to SDA and SCL through 0ohm resistors?
…
Part Number: INA220-Q1 Hello, TI Support Team.
I have two questions.
My Power supply is 5V and I want to Monitor a power of CPU.
Power Supply ------ FET(Ideal diode controller) ------ Power Monitor -------- CPU
(5V) (5V)
First of all, Can…
Part Number: INA220-Q1 Other Parts Discussed in Thread: INA220 , INA228
Hi ,TI team
The below is the input sense voltage range as in below table for INA220. For various PGA modes ( 1 to 8) as enclosed from data sheet table 7.5
We want to…
Part Number: INA220-Q1
Hey TI Team,
We are running into an issue with the INA220-q1 chip being used to read voltages. Not sure if this has to be handled in the ADC or from our end. When we are reading the Bus Voltage Register (address = 02h), with…
Part Number: INA220 Other Parts Discussed in Thread: , DRV103 , INA230
Hello,
I'm using an INA220-Q1 to measure several types of loads. Some are resistive with a 100% duty cycle, others are resistive with a high duty cycle ~75%, and others are inductive…
Part Number: INA220-Q1 Other Parts Discussed in Thread: INA220 Dear, Sir.
My cistomer is considering to apply INA220-Q1 for their system.
Now, they are asking anout the I2C Clock Ssretching function.
I tried to chack the datasheet, but it is not…
Part Number: INA220-Q1 Other Parts Discussed in Thread: INA226 , INA220EVM Hi team,
In the datasheet, we have only these following details:
« Iin+, Iin- Input bias current at IN+ and IN-« (Ta=25°C, active mode, Vin+ = 12V ; (Vin+ - Vin- ) = 32mV,…
Part Number: INA220 Tool/software: Hi, I am considering using only the voltage detection function of the VBUS terminal. In this case, what happens to the connection of the unused IN+ and IN- terminals?
This has been answered before, but the answer is…
