Part Number: INA229-Q1 Other Parts Discussed in Thread: INA229 Hi,
I use the INA229 to monitor the current in a battery powered system.
From time to time, the current reading becomes wrong, with different behaviours from one failure to the other (small…
Part Number: INA229-Q1 Other Parts Discussed in Thread: INA129 , INA229 Hi expert,
We need to use VBUS for insulation impedance detection. The minimum voltage may be about 2mV. Could you help me confirm that the accuracy of Vbus can meet the requirements…
Part Number: INA229-Q1 Other Parts Discussed in Thread: INA229 , INA233 Team,
is there a feature that allows to check the integrity of the SPI messages sent from the device to an MCU?
My customer needs to have this since the INA229 is located in some distance…
Part Number: INA229-Q1 Other Parts Discussed in Thread: INA229 I'm using the INA229 in a battery system which can reach up to 80V when fully charged. Since this is close to the maximum allowable common mode voltage or Vbus voltage of the device, it is…
Part Number: INA229-Q1
Hi
We would like to use INA229-Q1(Power/Energy/Charge Monitor)
It is marked as activity on the ti website.
However, there is not stock.
and the sample is not active.
Is there a sample or way to buy? Thank you
Part Number: INA229-Q1 Other Parts Discussed in Thread: INA229 ,
The device is connected to a high side shunt in a 72V battery of an electric vehicle. It's used to measure the current and count coulombs in the battery of the EV. When I test the system outside…
Part Number: INA229-Q1 Dear team,
We are promoting INA229-Q1 to my customer for automotive BMS application, they said that quiescent current of the IC is high when in normal mode, they require 250uA quiescent current. I saw from datasheet that this device…
Part Number: INA229-Q1 Other Parts Discussed in Thread: INA229 We use the INA229 in continuous conversion mode (MODE = 0xF). Alerts are latched ( ALATCH = 1) to make sure the MCU does not miss a fault condition. We are also using the averaged value for the…
