Part Number: INA233 Other Parts Discussed in Thread: INA226 , INA230 , , INA236 , INA3221 Tool/software: Hello,
on which semiconductor technology are the following power monitors based?
INA226
INA230
INA233
INA236
INA3221
That could be helpful to evaluate…
Part Number: INA236 Hello expert,
May I know if you could provide power consumption of INA236 for us? In datasheet we only see Iq spec but it is not operating current I'm afraid to underestimate it. Thanks!
Best regrads,
Ann Lien
Part Number: INA236 Hi,
I am doing a design with INA236. I am trying to follow the datasheet for configuration, but the calculation and setting don't make much sense. Here it is:
Rsense = 0.1 Ohm
Imax - 0.2048A (I selected it for "easier" conversions…
Hi Mohamed,
Now i use Arduino IDE to test the INA236EVM.
Do TI have any Arduino library of INA236 which i can use to test the current sensor?
How can i add those INA236 sysConf file into my Arduino library so that can use it for current sensing?
I got…
Part Number: INA236 Hello,
I plan to measure current, voltage and power using the INA236 integrated circuit. I read the datasheet, but I could not find the maximum power limit that the integrated circuit can measure. Can you give me information about…
Part Number: INA236 Other Parts Discussed in Thread: INA226 Hi,
In comparison table : https://www.ti.com/amplifier-circuit/current-sense/products.html
INA236 has no Bandwidth specified :
While INA 226 ( which has identical gain vs Frequency characteristic…
I specifically used the INA236 due to its 20mV full scale range and high precision for a 5 x 400A sensing device. So the low burden voltage makes it possible on MCPCB. This leaves the INA228 on the table with its 20-bits allowing for a similar 20mV range…
Hello,
Thanks for sending those communication images, but do you by chance have images taken with an oscilloscope instead of a logic analyzer? The reason I ask is because that helps me evaluate noise levels and timing requirements that may be causing…
Part Number: INA236 Hi,
I have a basic question about the INA236 least significant bit (LSB) size versus the full-scale (FS) value.
Why does it appear that the full 16-bit resolution is not being used? It appears that the device is actually a 15-bit…
Part Number: INA236 Other Parts Discussed in Thread: INA228 Hello,
We are using INA236 in our design. I have two questions about the response time of ALERT signal.
Question #1
According to section "8.2.3 Application Curves", when fault conditions are…