Part Number: INA240-Q1 Other Parts Discussed in Thread: INA240 Hi Team,
I am using INA240A1-Q IC in my project.
Circuit:
Shall i use Rs ( R0505 & R0506) value from 330 ohm (>300ohm) in place of 30 ohms ??
Are these values impacting the any…
Part Number: INA240 I've noticed that the SPICE model for the INA240A1 does not match the datasheet for PSRR. While the datasheet specifies a PSRR of 10 uV/V max, the model is demonstrating 0.5 V/V. As far as I can tell, I've replicated the conditions…
Part Number: INA240 Other Parts Discussed in Thread: INA301 Hello everyone, I am currently using the INA240 (A2 so gain is 50V/V) to measure the current for a buck converter and I am struggling to get rid of the noise on the output of the INA240, which…
Part Number: INA241A Other Parts Discussed in Thread: INA240 Tool/software: Hello everyone,
In my project, I am driving valves so that I am using INA240 to read current sense on my custom board. You can see my INA240 design below.
I am doing BCI…
Part Number: INA240 Other Parts Discussed in Thread: INA241A Hi Expert,
I found in INA240 datasheet, the package of SOIC-8 is 4.90mm × 3.91mm:
but at end of datasheet, the package is different:
Question:
which one is correct?
Can INA240…
Part Number: INA240-Q1 Hi Team,
I found safety manual document in Ti website. I am doing FIT rate calculations for INA240A1-Q1 IC based on my project requirements.
I need component type of INA240A1-Q1 IC.
In that document, they mention as BICMOS…
Part Number: INA240 If there is a variation at the INP and INN voltage for a time duration of 200nsec from the steady state value: will the output of the INA240A3 changes??
As per the datasheet, INA240x are compatible for Enhanced PWM rejection. …
Part Number: INA240 I am working on creating a current sense circuit for monitoring the current of source with below specs:
Current Source: Amplitude (-30mA to +30mA, 80Hz, 50% Duty cycle PWM). I would like to give the analog output of the Opamp to…
