Part Number: INA240 Hello,
In the application report SBOA172, a couple of waveforms corresponding to the output response of the INA240 with respect to the input common-mode step change were provided. However, I have a small query with respect to those…
Part Number: INA240-Q1 Other Parts Discussed in Thread: INA240 Hi team,
My customer is using INA240-Q1 similar to below configuration, but unfortunately they use the output in single-ended signal.
Could you help share the internal impedance variation…
Part Number: INA240 Hi,
A current probe was inserted at the measurement point of INA240, and two waveforms of ①INA240 output voltage and ②current probe were acquired with an oscilloscope and compared.
As a result, ①the INA240 output voltage waveform…
Part Number: INA240-Q1 Other Parts Discussed in Thread: INA240 Hi Team,
My Software Team is Facing issue in Reading ADC Results in Software ,
Programming is Implemented as per Datasheet Guideline .,
But its Showing Wrongs Vales ., ( We are in Mass…
Part Number: INA240 Other Parts Discussed in Thread: INA241B , INA241A Team,
my customer needs more accurate input bias current specifications for a tolerance analysis. The datasheet only references typical values.
Could you please provide a graph…
Part Number: INA240 Other Parts Discussed in Thread: REF2033 , INA500 , INA170 , INA132
Tool/software:
Hello experts,
We are looking for a (preferred)single chip solution , which does the following, with one major change.
The differential inputs…
Part Number: INA240
Tool/software:
Hello everyone,
I have problem about reading the current output during BCI test (0-400MHz, 100mA). You can see my INA240 design below. I design the input as a kelvin connection and same layout for both INA.
I…
Part Number: INA240 Dear Team,
Hope you are doing well!
Recently our customer is using INA240 to measure the current.
The schematic diagram is shown as below:
The customer referred the typical application in the datasheet.
Could you please…
