Part Number: INA241B Hello,
We're designing with the INA241B and had a quesiton about using an opamp to buffer that input.
It doesn't seem like this is necessary, but i found another post discussing better accuracy with the opamp.
Could you please…
Part Number: INA241B-Q1 Other Parts Discussed in Thread: INA241B , INA280-Q1 , INA281-Q1 , INA253-Q1 Tool/software: Dear Support Team The product page for the INA241B-Q1 lists a gain option of 500V/V, but this is not mentioned in the datasheet. Is there…
Part Number: INA241B Tool/software: I'm looking to save some power on a design, I was thinking I could turn off Vs, so Vs would be floating. Is this safe if voltage is still applied to In + / - across the current sense resistor. The main voltage in is…
Part Number: INA241B Tool/software: Hello,
I'm working on a servo driver board with inline current sensing. Initially, I used AD818 current sense amps but after testing decided to switch to INA241B2. The chips appear to be pin for pin compatible, except…
Part Number: INA241B Other Parts Discussed in Thread: INA241A
Hi expert,
My customer application scenario is test and measurement ATE equipment. They used INA241A to measure one of the power rails of -12V, like below figure. The Vs is connected to…
Part Number: INA241B Tool/software: Hi Team
Customer plan to use INA241 as current sensor on 48V bus. they concern that the distance from IN- to GND's is not enough, they needs 0.6mm between output to gnd. Do you have some insight if there is risk for…
Part Number: INA241B Other Parts Discussed in Thread: INA241A , INA240 Tool/software: Hi team,
My customer is using INA241B for solar inverter high-side current sensing. But in test waveforms, INA241 output can follow actual current change at the beginning…
Part Number: INA241B Tool/software: Hi Team
Customer uses INA241B as the output current sense. The schematic is shown as following, the output voltage is 48V. they found the INA241B output is abnormal after applying the 8.8KV ESD test on output GND4…
