Part Number: INA286 Other Parts Discussed in Thread: INA282 , INA293
Hi, Support Team
1. The load is an electronic load with CC mode and we have also applied a CV on Shunt-Resistor to generate a DC current (all PWMs and Power Stage are stop), the output…
Part Number: INA286 Hi,
When the INA286 is connected unidirectional configuration , will it be damaged if current flows bidirectionally?
Actually I want to measure current that flows from supply to battery but also the load is connected to battery.
I…
I removed R12 (56Ohm resistor) and now it is even worse. The INA286 GND is connected to IN- (Kelvin Connection) and I'm just giving a PWM signal on the outputs, there is no current flowing that could cause a GND variation. I'm really struggling to understand…
Part Number: INA286 Other Parts Discussed in Thread: INA826 , Hi, support team
My customer has the questions as follow:
There is a problem with my simulation. Datasheet shows that the common mode input voltage range from -14V to 80V. When the common mode…
Part Number: INA286 Hi,
Good Day. The quiescent current gives the current consumed at no load condition. Customer wants to calculate current consumed at varying load. Can you give details on how to do this? Thank you very much.
Best Regards,
Ray Vince…
Part Number: INA286 When design with INA286, using the following reference Design Circuit:
the power supply is 50V,the sampling resistance is 0.015R, V+ is 3.3V.
My question is Why the output is a Saw-Shaped waveform with a frequency of about 10KHz. …
Part Number: INA286-Q1 Other Parts Discussed in Thread: INA286 HI team,
My customer is asking the current consumption on the INA286 REF1 and REF2 pin, is there any spec?
Also what's the current consumption for the V+?
Thanks
Part Number: INA286-Q1 hi Team,
in the DS section
7.4.1.2.3 Splitting an External Reference
in such connection, the DS mention about it's able to achieve and accuracy of approximately 0.5%
can you help elaborate what's the accuracy it's actually…
Part Number: INA286-Q1 Other Parts Discussed in Thread: INA286 , TLV313 , I would like to detect 0.1mv--20mv of a 2mohm R(current is 0.05mA~10A)，
the INA286's output is 10mv--2v. The AMC1211's output is (1.44-1~1.44+1),
the TLV313's output is 1.5…
Part Number: INA286 In the datasheet it mentions an internal clock (page 14), but no information about the frequency or how to use it.
- what is the clock frequency?
- how do you use it?
- why does this part have an internal clock?
Thank you!
