Part Number: INA286 Hi Guys
Our customer will use our INA286 as high side current sense. Typical common mode voltage is 48V. But we have some questions:
1. If we power off our device, but the main power voltage is high voltage 48V. So at this no power…
John,
I could not yet figure out a clever workaround for the main error, but I hope to have a brute-force solution later today.
The .lib files didn't seem to be included in your Cadence hierarchy. It's not a big deal for the INA286, but what model…
Part Number: INA826 Other Parts Discussed in Thread: INA286 , Hi Everyone,
I am using INA826 for current measurement. Input SHUNT_A and SHUNT_B is connected to 100R resistor for current 0-10 mA. I have problem because when current circuit is open (current…
Part Number: LMP8603 Other Parts Discussed in Thread: INA286 , INA240 , INA270 Hi Team,
I am looking for a pin compatible LMP8603 (VSSOP package) device with the same internal 2 nd order filter, but with much better CMRR figures like for the INA240…
Part Number: DRV8300DIPW-EVM Other Parts Discussed in Thread: INA240 , INA286
Hi,
I'm using a DRV8300DI (Inverted) gate driver IC and at the moment I have some trouble with the current measurement (Low-Side Measurement).
I already have an article…
Hi Raphael
Thanks a lot for your answer, it's clear now for me to understand the Ib and Ios to face our piezoelectric sensor application, and I think INA286 is adequate.
I also get support from FAE Cera Wei from TI, I will test our sensor when the…
Part Number: INA199 Other Parts Discussed in Thread: INA286 , INA281 , INA293 , Hi team,
i am SC MM FAE focused on Test Measurement, My customer Dreamsun is a BTS customer who used INA199A2.
They use the input resistor 1Kohm because of the reverse…
Part Number: INA186 Other Parts Discussed in Thread: INA282 , INA286 Hello,
I want to use the INA186 to measure a +/-12V boost converter with one INA186 on each rail. Note that the INA186 supply voltages are provided separately by a 3.3V regulator.…
This is for a current controlled dc motor application. Here DRV8432 IC is in a bridge mode for driving a single motor. Motor Current is measured using two shunt resistors and INA286 current amplifier ICs. INA286 ICs are powered through a 7805 Voltage…
Hello Mr Edward, I have finished the design of my PCB and i am sending it for printing on Monday. Before that i would like to make two short questions. (As i told you at my previous messages, i would like to make AC current phase sensing.) The first one…
