Part Number: INA293-Q1 Other Parts Discussed in Thread: INA293 Tool/software: What is the recommended approach to adding a common-mode filter to the input of an INA293?
Datasheet section 8.1.2 addresses differential mode filtering, but not common-mode…
Part Number: INA293-Q1 Other Parts Discussed in Thread: INA293 , INA281-Q1 , , INA310A Tool/software: Hi,
Currently, we need to achieve current sensing data with a bandwidth of over 2 MHz on the platform.
We have surveyed the TI INA293, which can provide…
Part Number: INA293 Tool/software: Hello, I've calculated the Rshunt selection and current range for measuring AC current (up to 1A) with a 1MHz bandwidth using the INA293. I'd like to confirm if my approach is correct.
[Background] - Measurement…
Part Number: INA293 Other Parts Discussed in Thread: INA296B , INA296A Tool/software: Hello everyone,
I'm looking to measure AC current and observe its frequency characteristics up to 1MHz. I've chosen the INA293 for this task, but as a beginner with…
Part Number: INA293 I need to measure the current of a signal with at least 1 nanosecond precision. The signal is a 400kHz square wave with under 20% duty. This signal will have a peak voltage of 50V and a peak current of 4.5A. Is the INA293 good enough…
Part Number: INA293 Other Parts Discussed in Thread: OPA188 , BUF634A , THS3491 Hi Team,
I want to design an electronic dc load. I drew a test board as in attachment. I have some concerns and questions about the design in schematic.
1. I plan to use INA293…
Part Number: INA293-Q1 We have a simple current sense circuit and we measure the current from a 2 mOhm sense resistor from a high side of 28 Vdc.
Current to be measured is inductor current which has a switching frequency of 300 kHz.
Below CH2: Voltage…
Part Number: INA293-Q1 Other Parts Discussed in Thread: INA293 Hello, I am using INA293A4QDBVRQ1 in a design. I placed the current sense circuit near the power input so I can measure the current of the whole board. When I measured the current, I got very…
Part Number: INA293 Hallo together ,
we are planning a design with the INA293B1, where we want to measure a shunt current and want to detect a short-circuit current.
To detect the short-circuit current as fast as possible we need the full slew rate of…
Part Number: INA293 Hello guys,
One of my customers is considering using INA293 for their new products. They have the following questions at this moment. Could you please give me your reply for them?
Q1. Is INA293 output topology push/pull type? Q2. What…